Part Number: TLA2024 Tool/software: Hi,
We’re encountering unexpected behavior with the TLA2024 ADC during initialization and single-shot operation.
The Issues:
Config Register Default (0x02):
On power-up or reset, the configuration register…
Part Number: TLA2024 Tool/software: Hello,
I am using the TLA2024 to measure four single-ended signals in the range of 0 to 5V. This ADC is connected to a microcontroller with 3.3V I/O.
My question is: is it possible to power the TLA2024 with a 5V…
Part Number: ADS1015 Other Parts Discussed in Thread: TLA2024
Tool/software:
Hi experts,
May I learn from you what are main differences between ADS1015 and TLA2024 except temp range? Customer would like to choose a solution for temp sensing with…
Part Number: TLA2024 Hi TI service team,
This is Paul from ZT hardware team.
To be more clearly, we utilize these two AIN pins (AIN0 and AIN1) for voltage sense ( actual voltage from mutimeter on board: 1.6v~2.82v ) and convert this value (must a…
Part Number: TLA2024 Tool/software: We are using the TLA2024 in differential mode and have noticed that if the input voltage rises more than Vcc or less than GND, the data output appears to invert. Is there a condition internally where a buffer or amp…
Part Number: TLA2024 Other Parts Discussed in Thread: , ADS1115 Hi Experts,
Our customer would like to ask if it would be possible to communicate with TLA2024 via I2C-to-USB adapters like https://www.adafruit.com/product/4471 for debug purposes using…
Part Number: TLA2024 Tool/software: Hi experts,
I read the result register for current measurement 1000 times. I found that I got negative value(unit: V), but it shouldn't be like this.
here is our pin definition schematic.
I need you double…
Part Number: TLA2024 The following images depict a scenario in which, after writing 0x5383 to the Configuration Register (0x01) of TLA2024 (0x48), then immediately subsequent read of that register yielded a value of 0xD3FF. There appears to be an issue…
Part Number: TLA2024 Example Board Layout wrong measurements wrong:
In the TLA2024 Datasheet page 34 the total measurement of the suggested Footprint is 1.85mm. But the sum of 0.58mm + 0.58mm (for both pads) and the distance between the two pads 0.7mm…
