Part Number: TLA2024 Example Board Layout wrong measurements wrong:
In the TLA2024 Datasheet page 34 the total measurement of the suggested Footprint is 1.85mm. But the sum of 0.58mm + 0.58mm (for both pads) and the distance between the two pads 0.7mm…
Part Number: TLA2024
Hello,
We need to confirm our observations:
1. For TLA2024 If we configure input multiplexer AINP = AIN0 and AINN = AIN1 we are not able to read correct differential output. Is it recommended to use AIN0 & AIN1 channel for differential…
Part Number: TLA2024 Hi,
I'm trying to read a voltage of +85 mV with the default FSR setting and at high sampling rate of 3.3 k SPS. But voltage readings are not accurate. TLA is showing a different reading from run to run: 150 mV in one run, -83 mV…
Part Number: TLA2024 Section 8.5.2.1 in the TLA2024 data sheet only shows I2C reads using stop followed by start (after the register pointer and before the read command). However in the I2C timing requirements, section 7.6, there are values for repeated…
Part Number: TLA2024 Dear Sirs.
Could you let me know why ESD test is not performed in the Qualification report of PCN#20221219004.1?
ESD test can be found in PCN#20221219007.1 and PCN20221216004.1 issued at the same time.
Best regards.
Tsuyoshi…
Part Number: TLA2024 Other Parts Discussed in Thread: ADS1015 Hello,
We are reading adc value for input ac voltage of 1.5v on channel AIN0 and 2.2v on channel AIN1 in differential mode. We are reading peak to peak values and verified it on oscilloscope…
Part Number: TLA2024 Hi,
My customer use TLA2024 for new project’s openbmc FW development.
They only find the iio driver for TLA2024, does the device have hwmon driver support for openbmc?
Part Number: TLA2024EVM-PDK Hi,
I am using TLA2024EVM-PDK evaluation board. But i am facing accuracy issue. I am observing maximum 17mV difference between measured value and the data received from I2C. below are the results,
Vsense(Measured…
Part Number: TLA2024 HI, Staff
Let me ask you a question about the operation of TLA2024IRUGR.
I got the AD value with the input open while the 4ch input was enabled. The result is a value of 200-400 mV. I thought that the expected value would be 0V…
Part Number: TLA2024 Other Parts Discussed in Thread: ADS1015 Tool/software: Linux Hi
We are using a TLA2024 ADC for which there is no linux driver available.
we have observed the both ADS1015 and TLA2024 are similar to each other.And the ads1015…
