Part Number: TLC04 Tool/software: Hi,
The input of my TLC04 is connected to the DAC of an STM32F4 and the output is connected to an oscilloscope. The DAC should output a simple sine wave (with some noise) however, the oscilloscope shows a square wave…
Part Number: TLC04 Tool/software: Hi,
Good day.
Customer claimed that they encountered solder test failed on received parts (PN#TLC04ID) which with extended shelf life (DC1952+5). See attached test report.
Therefore, they would like to clarifying…
Part Number: TLC04 Tool/software: Hi,
Good day.
Customer claimed that they encountered solder test failed on received parts (PN#TLC04ID) which with extended shelf life (DC1952+5). See attached test report.
Therefore, they would like to clarifying…
Part Number: TLC04
hi,
i am using this filter in my design. i need cut off frequency of 200Hz,so i have set C=0.1uF and R=560 ohms( i have changed on board which is not same as in schematic) for which clock frequency will be 10.5KHz (not an issue…
Part Number: TLC04 I am using the TLC04 in a single supply operation. It would appear that I need to use the circuit from Figure 6 of the latest datasheet. From this figure and the "Terminal Functions" table on page 2 of the datasheet, I have the part…
Hello Mohamed,
The TLC04 can be used with a 5 V supply. The resistors and capacitor between VCC+ and AGND and GND do not need to be changed. These are setting AGND to midsupply.
The TLC04 cut off frequency is 1/50 of the clock frequency. For your…
Part Number: TLC04 Hi Dear All
i have LTC04 fourth order low pass filter.i have to need use this in my project with single positive power supply and 8khz frequency low pass filter.
ic have to need generate Fclock=400khz for pass Fc=8khz(cutoff) signal…
Part Number: TLC14 Other Parts Discussed in Thread: TLC04 , Dear all,
Our customer try to use TLC14 or TLC04.
The customer wants to use TLC14, TLC04.
Are there any EOL plans for these two products?
If EOL is planned, are there any good 4th Butterworth…
Tom,
Thank you for your reply. Doing some more work into delta-sigma modulators I realised that what I was seeing could be correct (I thought originally it would be a 50% duty at the clock frequency). I found that the TLC04 gave me a very oscillatory…
Hi Ray,
If your budget can afford it for the design, have you considered a switched cap filter such as the TLC04?
www.ti.com/.../slas021a.pdf
Mike Tripoli
