Part Number: TLC59108F Other Parts Discussed in Thread: LP5018 Tool/software: Hi team,
Want to know the current consumption for TLC59108F.
The ICC current of TLC59108F is the same when All LEDs are on and All LEDs are off. Is it because there is no…
Part Number: TLC59108F While communicating my TLC59108F IC with STM32 development board, TLC59108F is continuously sending NACK. If the device address is configured as 0x80.Circuit Image is attached below.
Part Number: TLC59108F Hello,
I'm considering using a TLC59108F device for driving leds. I need to use it as ON/OFF driver, and I've seen this driver was using 2 separates PWM signals to set brightness and dimming. Therefore, for my ON/OFF application…
Part Number: TLC59108F Other Parts Discussed in Thread: TLC59108 Hi,
I am trying to use the TLC59108F device. The device reply to me well and I don't understand why it doesn't works.
In particolar, I configure the device by set normal mode into MODE1…
Part Number: TLC59108
Team,
Due to TLC59108 availability we checking to options to migrate to TLC59108F without any HW changes. Is it possible to drop-in TLC59108F instead of TLC59108? Can you please detail the consideration to migrate HW and SW from…
Part Number: TLC59108F Hello Expert,
I want to get confirmation about min. VIH level.
Our customer's condition is below.
VCC = 5.0V
I2C (SDA, SCL), RESET Level = 3.3V from SoC.
As I know, min. spec of VIH is 0.7xVCC.
So min. VIH is 3.5V…
Part Number: TLC59108F Hello community,
I am currently using a TLC59108F as PWM controller to drive LEDs, DC motor, ... That's working as expected, except the PWM frequency is greater than told in the datasheet : I can observe a frequency of 107.9kHz…
Part Number: TLC59108F Other Parts Discussed in Thread: TLC59108 ・Circuit conditions LED_Vf ：1.1～1.7V Number of LEDs ：7 R0～R6 ：68Ω Icc_max ：38mA ※Adjust the PWM Duty so that only 38mA flows at the maximum ・TLC59108F：Calculation of allowable…
Part Number: TLC59108F Hello Guys,
Good day.
On the datasheet of TLC59108F, it was mentioned that the External Reset input requires a pullup resistor to VCC if no active connection is used: what is the recommended value for the pullup resistor? In…
Hi Stefan,
"This E3E topic describes that the difference between TLC59108 and TLC59108F are just the output structure. (Current-Source / Open-Drain)"
Please note that they are the main difference between TLC59108 and TLC59108F, rather than TLC59108F…
