Part Number: TLC59208F Other Parts Discussed in Thread: TPS61199 Tool/software: What is the brightness level ratio
For example on TPS61199 (5000:1 PWM Dimming Ratio at 200 Hz)
Part Number: TLC59208F Hello,
I am trying to use I²C bus pins to set I²C adress of component as described on datasheet but it looks not working,
(I am connecting directly the I²C bus wire to Adressing PIn)
Does it need a special design…
Part Number: TLC59208F Other Parts Discussed in Thread: TLC591XXSW-LINUX , TLC59116 , TLC59108 Hi Experts,
Our customer is wondering if there was a Linux driver for TLC59208FIPWR-GP. Please share if available. Thank you.
Best regards,
Gerald
Part Number: TLC59108 Other Parts Discussed in Thread: TLC59208F Hi Team,
can you help with the following request of my customer:
I have now looked at the TLC59108 a little closer and am now more sure whether I can use this at all for my application…
Part Number: TLC59208F Hi Expert,
Customer would to know If the output pin is not connected to the LED, should we leave it floating or connect it directly to GND?
Regards,
Mark
Part Number: TLC59208F Hi Team,
Customer currently find an IC that can control 8 input IOs! These 8 IOs should be controlled as High or LOW. But the customer only has the function of I2C or UART Could they use TLC59208F & if don’t connect the LED, as shown…
Part Number: TLC59208F Other Parts Discussed in Thread: LP5009 , Hi team,
Please advise, About the LED driver TLC59208F, have we done relevant reliability tests, such as the definition of the life of the internal MOS switching times?
Or related test data…
Part Number: TLC59208F Hi everyone.
I will make a PCB using TLC59208F to control directly N-FET without any IC buffer, my load is only control Led.
So It will run normal or not?
Thanks for your answer.
Part Number: TLC59208F Other Parts Discussed in Thread: TLC59108F , , TLC59108 Hello Community,
i would like to be sure of the differences between TLC59108F and TLC59208F.
This E3E topic describes that the difference between TLC59108 and TLC59108F are just…