Part Number: TLC5926 Other Parts Discussed in Thread: TLC59108 Tool/software: Dears, (I've indicated a particular IC part number in the subject, but my question is more general, thanks).
I'm working on an audio project, and I'm searching for LED drivers…
Part Number: TLC5926 Tool/software: I am having an issue using the TLC5296 where the open error detection is always 0, and had a couple of questions, I saw where the voltage needed to be above 2.2 for the 5927 and the data sheet says that for the shot…
Part Number: TLC5926-Q1 Tool/software: In the datasheet of TLC5926-Q1 chapter 10.1.2 (Adjusting Output Current) is a calculation for the Output-Current (5). e.g. 26 mA at 720 Ohm. In Figure 16 the output current at 720 Ohm is approximately 40 mA. What…
Part Number: TLC5926 Other Parts Discussed in Thread: LP5890 Hi,
I want to design P3 RGB LED Display panel for 16x48 LED's Matrix using TLC5926. I have few questions as below,
1. What is refresh rate of TLC5926? Will it support for Video playing?…
Part Number: TLC5926 Other Parts Discussed in Thread: SN74HC595 , TLC59283 Hi,
I would like to use TLC5926 or similar part to turn on a group of LEDs in a sequential way (meaning turn on first LED for 100us, then turn it off and then at the same time…
Part Number: TLC5926-Q1 Other Parts Discussed in Thread: TLC5926 , TLC6C5716-Q1 Tool/software: Hi team,
My customer use PWM input on OE pin and they have troubled when PWM input is 100%(always High).
In that case, IC surface temperature rises by about…
Part Number: TLC5926 To whom it may concern,
We were checking the specs and prefered footprint for the TLC5926IDWR, and a couple of questions have come to our minds.
What would it be the specific circuit that the current follows through the TLC5926…
Part Number: TLC5926-Q1 Tool/software: The datasheet defines RθJC(bot) thermal resistance, does this indicate junction-to-thermal pad thermal resistance?
Part Number: TLC5926 Hello,
I'm using a single TLC5926 to drive 16 LED strings. I have coded the error detection function. Surprisingly, the first time I call the error detection function, the MISO signal only returns '0' even whatever the string status…
