Part Number: TLC59711 Hello, I am trying to drive a brushless DC motor with an APF27 but I do not have enough PWM output. Therefore, I tried to use the TLC59711. I used exactly the same design as the one presented in the datasheet (with a 3.3 kOhm resistor…
Part Number: TLC59711 Hello, We are testing the TLC59711 for our applications but we are experiencing some problems. For now, we only have 2 RGB LEDs connected to Out0 and Out3 and if we try to turn on the other outputs the LEDs start to flickering. We…
Part Number: TLC59711
In this manual,
on page 20, there's a section called 224-bit shift register that describes the shift register as 224 bits wide but in the next section it mentions a 244 bit shift register. Which one is correct?
Part Number: TLC59711 Other Parts Discussed in Thread: TIDA-00979 , TLC5971 Hi,
I am using RGB LED drivers (2 No's) in daisy chain to drive 8 RGB LEDS. When I try to drive single RGB LED with yellow color, other RGB LEDS are flickering with same yellow…
Thank you Kenneth for your response.
Please find the schematic as below:
LPC1115 board and Adafruit eval board:
Schematic of the Adafruit TLC59711 eval board:
Moreover, as I have two unknowns: Firmware and Hardware.
Can you please…
Other Parts Discussed in Thread: TLC5971 , TLC59711 Hey @all,
are the two drivers protocol compatible?
what are the real differences? on thing i can see at a fast look is the TLC59711 has a max clock rate of 10MHz - the TLC5971 has 20Mhz.
are there…
Other Parts Discussed in Thread: TLC59711 Hi,
I used the TLC59711 in a neurobiology research project that I am about to write up for publication. Since I used essentially exactly one of the datasheet's Typical Application Circuit Examples, it would…
Hi Dan,
FYI, even though you seem to no longer work on this...
For my setup (Arduino Uno, Adafruit boards), SPI_MODE0 worked even at 8MHz but I used different wiring from you since I noticed wiring bugs in Adafruit's "learn" article, see my post to…
Hello Mike,
Thanks for your answer, as expected I measured a 20kHz on each output. For my project I need to drive 12 high current output (4>6A Led), so I try to find a interface between the collector output of TLC59711 and power N mosfet. I've try several…
