Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.



Search tips
Showing 26 results View by: Thread Post Sort by

  • RE: DAC8820: Suggestions required for a low noise, fast settling DAC for pretuning VCO in a PLL

    Hello, The DAC8820 and TLC7524 parallel MDACs are going to be the fastest settling. The settling time will be dominated by whichever device (DAC or op amp) has a higher settling time. To meet the settling time spec in the datasheet you'd need to find…
    • Answered

  • TLC7524: Propagation delay clarificaiton

    Resolved
    Part Number: TLC7524 I don't fully understand the relationship between the propagation delay and the settling time - please clarify: Is there a total of 100nsec from the application of the data/rising edge of the write strobe for the output to be…
    • Resolved

  • TLC7524: About Voltage Mode Operation

    TI Thinks Resolved
    Part Number: TLC7524 Hi, I'd like to know about following 2 questions, 1. There's a difference between functional block diagram( on D/S page2) and figure 1(on D/S page5), In figure 1, there's a "R" at REF input , but in functional…

  • RE: DAC0802: Part suggestion

    Hello David, TLC7524 would be a good substitution and it has parallel interface. Thank you, Illia Volkov
    • Answered

  • TLC7524,GAIN in Unipolar Operation

    Resolved
    Other Parts Discussed in Thread: TLC7524 I'm designing this schematic about TLC7524, Unipolar Operation Could you clarify this information about GAIN adjustment: datasheet pg7 "RA and RB used only if gain adjustment is required" but not specify anyt…
    • Resolved
    • Answered

  • TLC7524 basic question

    Resolved
    Other Parts Discussed in Thread: TLC7524 Hi, I would like to ask you basic questions about TLC7524 as below. Q1) propagation delay timing I do not understand well about the start timing of the delay. There describes the start timing is "digital input…
    • Resolved

  • DAC TLC7524 as BDAC

    Other Parts Discussed in Thread: TLC7524 , DAC8541 Hello, I have designed a circuit using TLC7524 in BDAC (voltage) mode. I have run some test results already with a test bench circuit and the results were promising. How ever I would like your opinion of…

  • RE: DAC908: What is the minimum clock frequency for the DAC908?

    Hi Fabian, Why not consider a precision DAC? Our MDACs are designed for a lower sample rate, but achieve better dynamic performance (THD, SNR) than higher speed converters when operating at a lower speed. Take a look at the TLC7524 or DAC8806 Thanks, …
    • Answered

  • TLC7524 DAC in voltage mode does not give expected output when set up as in data sheet

    Resolved
    Other Parts Discussed in Thread: TLC7524 , LM358 I have the TLC7524 setup in voltage mode as in data sheet and the highest voltage I can get with a +5v supply is 4.1v. Any thoughts? I notice that the output in voltage mode is pretty weak, it doesn't want…
    • Resolved
    • Answered

  • About the Vref of TLC7524

    Resolved
    Other Parts Discussed in Thread: TLC7524 , LM339 Hello everybody, Thanks a lot for your attention to my question about the use of the component TLC7524. Generally I use it for my design of the controler of stepper motor. The dac is used to translate…
    • Resolved

Didn't find what you are looking for? Post a new question.