Part Number: TLE2426 I would like to see a basic circuit diagram which incorporates proper use of a TLE2426 to bias the non-inverting input of an opamp to half the V+ power supply voltage
Part Number: TLE2426 Dear Texas Instruments
I purchased TLE2426CLPR via Digikey.
I thought that TLE2426CLPR is TO-92 (straight lead (leg)),
but I got formed lead type instead of straight lead type.
If I'd like to get straight type, what part number should…
Part Number: TLE2426 Other Parts Discussed in Thread: TL081 Hi
I have quick questions regarding TLE2426IDR. We are using this virtual ground to our transimpedance amplifier so we do not have to use rail to rail power supply.
The issue is when VCC or ground…
Other Parts Discussed in Thread: TLE2426 Hello,
I plan using TLE2426 as a rail splitter in a OTA single supply application.
When I sim the schematic, there is no obvious problem.
However, I have 2 concerns :
1° What about the PSU bypass capacitors ?…
Part Number: TLE2426 Is there an optimal type of capacitor that should be used for the noise reduction capacitor?
I.e., a ceramic, film or electrolytic? My best guess is a ceramic, but that's only a guess.
The datasheet is a very thin on information…
Part Number: TLE2426 Other Parts Discussed in Thread: LM324 , I am trying to create a small twin stereo audio pre-amplifier to correct a small level correction problem between two audio units which looks to need a gain factor of 3 to 5. I have 10v to work…
Part Number: TLE2426 Other Parts Discussed in Thread: OPA548 Hello,
Our customer needs your help on below:
i am currently designing an op amp circuit and use a tle2426 for virtual ground. But i need to source/sink more current through the virtual ground…
Part Number: TLE2426 Other Parts Discussed in Thread: LT1054 , , TPS7A39 I am using an AD8170 ( https://www.analog.com/media/en/technical-documentation/data-sheets/AD8170_8174.pdf ) to create a 2:1 switch for HD-TVI cameras. I need to create a single power…
Part Number: TLE2426
Tool/software: TINA-TI or Spice Models
Hi,
I have been working with Tina-Ti to create a design for an inverting opAmp circuit using an OPA350 or equivalent as a voltage follower whose input comes from a INA121, and which runs off…