Part Number: TLV320ADC3100 Other Parts Discussed in Thread: TLV320ADC3120 Hi,
We are using the TLV320ADC3100 audio codec for our project. We write in the register first, and then we verify it by reading the registers. However, the value we get after…
Part Number: TLV320ADC3100 Other Parts Discussed in Thread: TLV320ADC3120 Hi Team,
I want to confirm if there is any small package of TLV320ADC3100 will be pushed such as DYY, DDF, DDC... And could you share the small package information and RTM time…
Part Number: TLV320ADC3100 Hi, team,
Customer wants to have 2 filter here:
1. HP filter, with cut off frequency 300hz,
2. HP filter with cut off frequency 200Hz.
Can we help them to calculate the 6 registers (Register 8~13) of Page 4?
Thanks…
Part Number: TLV320ADC3100 Hi, Team,
Customer found the audio signal, after TLV320ADC3100 processing, there is some noise cancellation effect. This can cause the sound to be less permeable or distorted in certain situations. Customer did not find the…
Part Number: TLV320ADC3100 Hello,
My customer is asking about single- ended mode on TLV320ADC3100 .
1) When IN2L/IN2R （ or IN3L/IN3R ） will be used on single- ended mode,
what should they do with the unconnected input pin (IN2L/IN2R or IN3L/IN3R…
Part Number: TLV320ADC3100 Hello,
I am using the TLV320ADC3100 in a design and have not been able to get the right channel to send data. I have managed to get audio out of the left channel, however.
The design uses IN2L and IN3L in a differential…
Part Number: TLV320ADC3100 Other Parts Discussed in Thread: PCM1862 Hi Sir,
I checked ADC3100 d/s looks can only set to 2 Differential mode(IN2L and IN3L, IN2R and IN3R), or 4 single end(IN2L,IN2R,IN3L,IN3Rsingle end).
If possible set to 1 Differential…
Part Number: TLV320ADC3100 Other Parts Discussed in Thread: PCM1808 , Hello expert,
May we have your help to find the replacement for ES7202? Thanks a lot!
http://www.everest-semi.com/pdf/ES7202%20PB.pdf
Best regards,
Ann Lien
Part Number: TLV320ADC3100
Hello All,
Greeting.
I am trying to perform read/write register for Page 4 via I2C control bus. But when I am trying to write and read back the register value, it always give me "0". I have checked the scope and it shows…
