Search tips
Showing 377 results View by: Thread Post Sort by

  • TLV320AIC3100: TLV320AIC3100

    TI Thinks Resolved
    Part Number: TLV320AIC3100 Other Parts Discussed in Thread: PCM3070 I just installed Purepath Studio and want to use it to design the DSP portion of a TLV320AIC3100. The GDE only shows frameworks for PCM3070 and PCM51xx How do I apply this to the TLV320AIC3100…
    • Answered

  • RE: TLV320AIC3100: TLV320AIC3100

    Resolved
    Too bad about the (lack of) GUI support. This is a great device and when I get it working it will save me a lot of cost in out new product design. I’ll try what you suggested and open a new thread if I get stuck.
    • Answered

  • RE: TLV320AIC3100: Audio playback configurations of TLV320AIC3100 for 32KHz,16 bit , mono audio data

    Resolved
    Hi Neethu, Can you send a recording of the vibration you're hearing? Also can you measure again the output of the amplifier (with the LC filter) to confirm the glitches in the sinewave have been resolved? Thank you, Jeff McPherson
    • Answered

  • TLV320AIC3100: TLV320AIC3100 shutdown

    Resolved
    Part Number: TLV320AIC3100 For the TLV320AIC3100, is there a single command or hardware condition to put the device in a low power (sleep) state? Or must I separately shut down the Class D amp before removing power from IOVdd and DVdd>
    • Resolved
    • Answered

  • RE: TLV320AIC3100: tlv320aic3100 24mhz driver support

    Resolved
    Please use one thread, this is the same as the this. (+) TLV320AIC3100: Microphone audio was not coming in the tlv320aic3100 codec - Audio forum - Audio - TI E2E support forums I'll close this.

  • RE: TLV320AIC3100: Microphone audio was not coming in the tlv320aic3100 codec

    OK good to know, we'll close this thread.
    • Answered

  • TLV320AIC3100: IOVDD current

    Resolved
    Part Number: TLV320AIC3100 Hello, Could you please confirm that in the data sheet on page 121 Table 8-1 there is an error in IOVDD spec , it should be 3.3V not 3.3A. Are you also able to share typical current consumption for IOVDD =1.8V for this chip…
    • Resolved
    • Answered

  • TLV320AIC3100: How to disable I2S on EVM?

    Resolved
    Part Number: TLV320AIC3100 Hi, Is it possible to prevent U1 MCU from occupying I2S lanes on ACEV-1A EVM so that I can test the DUT with another MCU via TPs? // Eetu
    • Resolved

  • TLV320AIC3100: tlv320aic3100

    Part Number: TLV320AIC3100 Can the analog ground and digital ground be connected to one ground plane layer in a 4 layer pcb layout? What restrictions would there be on decoupling cap placement and via connections to the ground plane?
    • Answered

  • TLV320AIC3100: ACEV-1A EVM export command list

    Resolved
    Part Number: TLV320AIC3100 When working with the ACEV-1A EVM GUI, it is possible to record and save (export) the command list but is it also possible to export the I2C register commands or do they have to be hand copied to the host firmware editor?
    • Resolved

Didn't find what you are looking for? Post a new question.