Part Number: TLV320AIC3101 Hi team,
Recently we found a random issue in customer side. After power up, TLV320AIC3101 occasionally can't output normally and the speaker has no sound. But we checked the I2S and it's normal. And then we checked the power…
Part Number: TLV320AIC3101 Hi experts
Our customer is using TLV320AIC3101,below is the schmatic,
SCHEMATIC1 _ 33 - Audio.pdf
And found that the outputs have noise
Here is the HPLOUT signal while no sound is sending
Here is the HPROUT signal while no sound…
Part Number: TLV320AIC3101 Other Parts Discussed in Thread: TLV320AIC3104 have noticed strange behavior in the Linux driver of the tlv320aic3x chip series. It seems that the driver is writing to a couple of reserved registers. Is this intentional? Is this…
Part Number: TLV320AIC3101 Hi, I developed a custom board hosting the TLV320AIC3101 audio codec, which communicates through I2S protocol with a Nucleo Board (STM32). Find here the schematic of the board:
As first test my idea is to implement a loopback…
Part Number: TLV320AIC3101 Hi team,
In datasheet of TLV320AIC3101, it describes that in master mode, BCLK can be generated with 32fs or 64fs. But I didn't find the register to configure BCLK. Could u pls help to explain how to get 32fs BCLK in master…
Part Number: TLV320AIC3101 Other Parts Discussed in Thread: TLV320AIC3106 , Hi ,
What is the difference between TLV320AIC3101 and TLV320AIC3106?
Could they use the same driver in Linux?
Jesse
Part Number: TLV320AIC3101 Other Parts Discussed in Thread: TLV320AIC3104 Our customer uses TLV320AIC3101 to generate pop sound, as follows:
1.Output level control=0DB;
2. When initializing TLV320AIC3101, if HPLOUT D0 is not enabled, no POP sound will…
Part Number: TLV320AIC3101 Hi Team, My case https://e2e.ti.com/support/audio-group/audio/f/audio-forum/1116288/tlv320aic3101-playback-noise-issue-on-tlv320aic3101/4139969#4139969 has been closed. But my noise issue haven't been changed with the latest suggested…
Part Number: TLV320AIC3101 I'm trying to operate the TLV320AIC3101 in the following configuration and I'm having difficulty confirming if my registers are set up correctly. Could someone look at my settings and let me know what is wrong?
48 kHz…
