Part Number: TLV320AIC3101 Other Parts Discussed in Thread: TLV320AIC3110 , Hello, What are the main differences between the TLV320AIC3101 and the TLV320AIC3110. Would I be able to use the TLV320AIC3101in place of the TLV320AIC3110? Thanks! Jerry
Part Number: TLV320AIC3110 Hi Team,
Need your help.
we are developing audio module on IMX8MM EVK board and A11 code
Changes:
+ sound-tlv320aic31xx { + compatible = "simple-audio-card"; + simple-audio-card,name = "tlv320aic31xx-Codec";…
Hi Peter,
Instead of being controlled by the IO expander, I try to pull the RESET to HIGH using another method, and here is the result.
As above scope shots, even the RESET pin can be released to HIGH successfully, but still, the I2C bus is halted by…
Part Number: TLV320AIC3110 Other Parts Discussed in Thread: TLV320AIC3111 , , PUREPATHSTUDIO In the 3110 datasheet, it is mentioned that the device includes a "Programmable Digital Audio Processor for Bass Boost/Treble/EQ With up to Five Biquads for Record…
Part Number: TLV320AIC3110 We have a design in which we are sending 16-bit samples at 8 kHz sample rate to be played on a Class-D speaker. The audio quality is fairly bad. Even sending a 440 Hz sine tone on the I2S bus results in a distorted sounding…
Part Number: TLV320AIC3110 We used 3.3V IO of FPGA to control TLV320AIC3110 and QFN32 chips. Now we want to use 1.8V IO to control TLV320AIC3110. Does TLV320AIC3110 support 1.8V IO control?
If 1.8V IO is supported to control, does the line change only…
Part Number: TLV320AIC3110 Hello, The datasheet for the TLV320AIC3110 mentions recommended power-supply sequence as follows: 1. Power up SPLVDD and SPRVDD 2. Power up IOVDD 3. Power up DVDD shortly after IOVDD 4. Power up AVDD and HPVDD However there is no…
Part Number: TLV320AIC3110 Hello, Does there need to be any sort of filtering on the speaker output? I am thinking of implementing an LC circuit on the speaker output but not sure if it's necessary. Any thoughts/recommendations? Thanks, Jerry
Part Number: TLV320AIC3110 I was going through the datasheet of the device and found that is supports 59.5 dB of Preamp gain. I need to calculate minimum audio signal level required at the input of this device for it to work properly.
Mic sensitivity…
