Part Number: TLV320AIC3204 Tool/software: Hello Everyone,
I am working on a project that involves using the TLV320aic3204 audio codec from Texas Instruments. My goal is to measure dB levels accurately. I've read the datasheet and application notes,…
Part Number: TLV320AIC3204 Tool/software: Hi Team, I want to achieve the following effect, but I do not know whether it can be achieved, please help me answer, thank you! 1. Use the I2C and I2S of the audio processing chip to control the 3204, so that…
Part Number: TLV320AIC3204 Tool/software:
HI,TI team
TLV320AIC3204 ,Reset the pin, when to give the high level, when to give the low level, can directly use the MCU IO port control?
Only for high and low levels, or do I need to give waveform?
Thank…
Hi Luo,
The AGC is present in the ADC signal chain, so the realized effect is through changes in the PGA gain.. If the INx inputs all have the same input signal level and the AGC gains up the signal to a defined value, each input will have the same result…
Part Number: TLV320AIC3204 Tool/software: Hello,
I used LO and HP channels of 3204 for ambient stereo, set the same AGC and DRC parameters, and LO and HP hardware circuit parameters are the same, but the compression curves of LO and HP output ambient…
Part Number: TLV320AIC3204 Tool/software:
The above picture is the schematic diagram we designed,
please help to see what other actions are needed to make the 3204 chip have current.
Or which ones are wrong.
Thank you very much!
Part Number: TLV320AIC3204 Tool/software: Hi Everyone,
Greetings for the day.
I am using TLV320AIC3204 Audio CODEC in one of my design. There are some unused pins in the design.
Unused pins - HPR, HPL, LOR, LOL
I want to know how to terminate these pins…
Part Number: TLV320AIC3204 Tool/software: Hello Everyone,
I am working on a project that involves TLV320aic3204 codec. I need to know the maximum and minimum voltage ratings (peak to peak as well as in rms) to the input IN1L for applying input from…
Part Number: TLV320AIC3204 Tool/software: Hi ti team,
I have a DECT module with a TLV320AIC3204 codec, and the MCLK (master clock) is set to 10.68MHz. I need to set the LRCLK (left and right channel clock) to 16KHz. How should I configure it?