Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.
Part Number: TLV320DAC3100-Q1 Hi team,
Could you please advise pin FMEA of the following case?
1. HPL (27pin), HPR (30 pin) are default power down which means those 2pins are High-Z at power up, correct?
In that case, Could you please advise the impact…
Part Number: TLV320DAC3100-Q1 Other Parts Discussed in Thread: TLV320DAC3100 Hi team,
We have some issue about TLV320DAC3100, and we did not find an exact description in the spec sheet.
1. Do PIN5, 13, and 14 only need to be connected to the corresponding…
Part Number: TLV320DAC3100-Q1 Other Parts Discussed in Thread: PCM5242 , TPA6120A2 , TPA6130A2 Hi team,
Could you advise the which TDM mode does TLV320DAC3100-Q1 support?
There is no detail information about TDM in the datasheet.
Does it support TDM16? …
Part Number: TLV320DAC3100-Q1 Hi, I'm using TLV320DAC3100-Q1 in a car to drive a 64 Ohm buzzer connected via a non-shielded cable of 3 meters.
From the radiofrequency analysis we noticed that emissions were above limits even without sending any audio…
Part Number: TLV320DAC3100-Q1 Hi team,
In order to calculate the power supply I would like to know the supply current of each supply pin of TLV320DAC3100-Q1.
Could you give me the typical and Maximum value of the supply current?
regards,
Part Number: TLV320DAC3100-Q1 Hi team,
I would like to know the minimum interval between beep generating function.
As described in the datasheet as below, new beep cannot be generated until previous beep has done, correct?
"A single beep is generated…
Part Number: TLV320DAC3100-Q1 Hi team,
Is there a failure mode in TLV320DAC3100-Q1 DC offset at Class D speaker output?
I concern the excessive DC offset on the output might damage the speaker connected.
#1. Is there such a failure mode?
#2. If yes, could…
Part Number: TLV320DAC3100-Q1 Hi team,
I would like to reduce communication commands between MCU and TLV320DAC3100-Q1.
Besides auto increment feature, is there any way to skip duplicated command such like sending the device address every time?
For example…
Part Number: TLV320DAC3100-Q1 Other Parts Discussed in Thread: TLV320DAC3100 Hi team,
I want to diagnose Reg.29 Overflow Flags and Reg.44 FAC Interrupt flags.
Could you advise the way to intentionally generate those flags in my board?
regards,