Part Number: TLV431B-Q1 Other Parts Discussed in Thread: TLV431 Tool/software: Hi Team, Required design calculation of below circuit and expected voltage across the 100nF capacitor. Please have a look into the link attached for the source document. High…
Part Number: TLV431B-Q1 Hi Expert，
How about the leakage current when the voltage of ref is close to 2.4V and 1.24V？
I would be appreciated if you could offer me an accurate number.
Thanks a lot
Part Number: TLV431B-Q1 Other Parts Discussed in Thread: TLVH431B-Q1 hello TI expert:
could you help me get failure rate for this part? it`s used by functional safety project.
thank you!
Part Number: TLV431B-Q1 Other Parts Discussed in Thread: TLV431A , , TLV431 Hello,
I am attempted to use the TLV431B-Q1 as a 3.3V shunt regulator in a design. The expected load will vary in capacitance (worst case 10uF) so I have a question regarding…
Hi Ross,
Thanks for the update. I would say switching to TLVH431B-Q1 would be the right decision. Designing with headroom is always good engineering.
Since the absolute maximum of the TLV431B-Q1 is not violated, I would expect the device to be functional…
Other Parts Discussed in Thread: TLV431B-Q1 , TLV431B , TLV431 Hi Expert,
I am a FAE from MM of CHINA. TL431B-Q1 was used in this customer. There is a failure case on customer side. Could you help on that?
It's better if you can send email back to…
Yusuf,
The correct power up of the board depends on the device selection. In particular, that 3.6V Zener diode is an important selection. In the AFE881H1 datasheet, there is a section on the start-up circuit. Here's the schematic shown:
The Zener…
Other Parts Discussed in Thread: TLV431B Hello everyone,
I use the TLV431B in the following configuration:
Transistor Q1 is used to drive high currents up to 100mA (TLV431B can drive maximum 15mA).
But, at high load currents(small R6), there…
