Part Number: TLV5614 Other Parts Discussed in Thread: DAC63204 , DAC63004 Hi Team,
If we have a new generation product update based on TLV5614, since customer plan to evaluate alternatives to KTA5614. Do we have products with smaller packages and higher…
Part Number: TLV5614 Hello team,
TLV5614 is used on a mass production project. About 1% of TLV5614 will have a problem that before MCU configure TLV5614 via SPI bus, the analog output OUTA~OUTD of TLV5614 will output 5V voltage (analog power supply…
Part Number: TLV5614 Other Parts Discussed in Thread: DAC60004 , DAC60504 HI TI expert,
my customer is using TLV5614 In a repeater project, now they want to know the θjA(℃/W) & θjc(℃/W) parameter of TLV5614 to calculate the power dissipation when TLV5614…
Part Number: TLV5614 Hello,
In my project, I will use the DAC TVL5614, but I want to know if it is possible to send data during the conversion in the first blocks.
For example, in the first time, I send a datum of 16bits with 20MHz clock frequency…
Part Number: TLV5614 Hi team,
In customer current design, a 1K ohm resistor is connected in series on the SPI port. If another capacitor to ground is added, the signal quality will deteriorate,
So they remove the ground capacitance of SPI port.
…
Part Number: TLV5614 Hi team,
Could you please help me double check:
1. Is the power consumption of the following table the total power consumption of IC or the power consumption of one DAC?
2. For TLV5614, can 4 DACs be separately controlled…
Part Number: TLV5614 Other Parts Discussed in Thread: DAC60504 Hello team,
We are using TLV5614 DAC in one of our design, when I power on and power off the power supply repeatedly, and I found some TLV5614 have issues as below:
1. The VOUTA~D of…
Part Number: TLV5614 Hello
My customer noticed the PSRR specification in the datasheet is listed as a negative number. As this is the 'Rejection Ratio' it should be a positive dB value.
Please queue this for a correction to the datasheet in the next…
Part Number: TLV5614-EP Hi, Good day. I hope everything is fine. Our customer wants to know the /PD pin voltage range when the Dvdd=3.3V and Avdd=2.5V. Is it possible to supply a 5V to /PD pin when the DVDD is 3.3V? I would appreciate your help on this…
