Part Number: TLV571 Other Parts Discussed in Thread: ADS7882 , ADC0820-N , , ADS7886 , ADS7040 , ADS8371 Curious to know if this is a supported thing to do. Does tying /RD low satisfy the requirement of the "dummy read" necessary to auto-config the device…
Part Number: TLV571 Hi there, I am using the TLV571 with 3V and 10MHz external clock. In the datasheet it states that the maximal sampling frequency is FRQ/16, i.e. 635ksps for 10MHz clock. However, interpreting the configuration confuses me: there it says…
Part Number: TLV571 Other Parts Discussed in Thread: TLC5510A , ADS7884 I have built an oscilloscope using the excellent TLV571 chip.
The results are good using Normal shutdown, however I cannot get Software shutdown to work.
Normal shutdown register…
Other Parts Discussed in Thread: TLV571 Hi,
The datasheet for the TLV571 states that the control registers are set at power-up, and latched at a rising -WR edge. Since there are two control registers, am I to assume each of the control registers are set…
Hi Satoshi-san,
as Tom mentioned, there is no such device on our roadmap. I don't think we or anybody else would develop an 8-bit, 1MSPS ADC with parallel interface anymore. From the devices you found you can see that those are quite old.
Also having…
Other Parts Discussed in Thread: TLV571 Hey smart people, I am a very amateur programmer and have been tasked with a problem that I am having some trouble with. I have an external Analog-to-Digital Converter, the TLV571, and I need to interface it with…
Hi Tom,
I apologise for the tardy response - I was expecting an email to inform me someone had replied!
I am using an ATmega8 MCU for data storage (as I am familiar with this MCU). I was going to use some cascaded serial-to-parallel converters, so…
