Part Number: TLV61048 Hello Team,
My customer wanted to locate pin 1 of TLV61048DBVR, can you share with us which is pin 1 on the photo below?
Regards,
Renan
Part Number: TLV61048 Hi
TLV61048DBVR output voltage should be 9.7V, but the only 8.xV on the failing part.
It has been confirmed that the customer’s voltage feedback resistor (R1, R7) uses 1% of the material.
The FB PIN with NG sample is 0.687V…
Part Number: TLV61048 For a TLV61048 configured to run at 1MHz, 3.5V to 6V, I'm seeing poor transient response. I suspect the output cap; it's a C3216X5R1E336M160AC (see attached). The SRF is right about at the switching frequency.
Comments?
…
Part Number: TLV61048 Team,
since there's no Webench for TLV61048, just wanted to double check: can TLV61048 provide 0.5A output current at 12Vout, boosting from around 5V?
Thanks
Part Number: TLV61048 I am working a boost converter with 2.7V-3.6V input range, with a nominal 12V dc output with nominal load < 50mA / step-load fo 500mA for < 100mS.
The boost converter works okay and reaches 12V output with a low load at Vin…
Part Number: TLV61048 Dear all,
I have a desiged a stepup converter with the TLV61048
Input voltage: 4.75-5V
Output voltage: 7.5V
Output current: 800mA
Is 7.5V with 800mA possible with this IC?
Best regards,
Jan-Willem
Part Number: TLV61048 Hello,
My customer is asking the following question:
Can you please verify that this IC is supports the following: Vin = 2.9 – 4.3, Vout = 11V, Iout = 0.4A?
Thanks.
Part Number: TLV61048 Other Parts Discussed in Thread: TPS61089 Can Input=5V/5A achieve output=12V in TLV61048 ?If can,what is the maxium output current?If the efficiency is 90%, then I_out=5*5*0.9/12=1.875A?Thanks!
Part Number: TLV61048 Other Parts Discussed in Thread: TPS61372 Dear
Schematic in attachment, when we have 30-45mA load the voltage drops to +-12,4/12,5V. How to fix this?
Greetings
Thomas Van Aken
Hi Volkan,
When TLV61070A is used and the max Vout is +5.5V, the -5.5V is hard to be achieved since the gap between the positive and negative output caused by the charge pump topology. The negative output may be like -4.7V. As your information, it should…