Hi Dorian :
About your question in the email 8/19, I think I had replied it again.
Could you use two TLV62085 EVM Board to test it?
I think it is very easy to copy about this issue.
====================================================================…
Part Number: TLV62085 Hi,
I have several Switching frequency and Over current protection for TLV62085 as attached file.
TLV62085_SW frequency.xlsx
TLV62085_Over current protection.xlsx
Could you please give me your help?
Regards, Nagata.
Part Number: TLV62085 Other Parts Discussed in Thread: TPS62810-Q1 Hi
I have two questions about EN of TLV62085.
1.Does this device have hysteresis at EN?
2.Are there the restriction about slew rate of EN?
Best regards,
Yokota
Part Number: TLV62085 Hi, Team,
Regarding the detection of Current Limit, in the data sheet "When this switch current limits is triggered 32 times, *******" Is this 32 times in a row? or is it total number of times?
Best Regards, Satoshi Yon…
Part Number: TLV62085 We are using TLV62085RLTR in our design which supports output voltage from 0.8V.
Based on our a design change, we are looking for an exact drop in replacement part f which will support output voltage of 0.7V with rest of the spec…
Part Number: TLV62085 Other Parts Discussed in Thread: TLV62585 Tool/software: WEBENCH® Design Tools I see a conflict between the data sheet PCB layout recommendation to the WEBENCH recommendation:
WEBANCH
Data Sheet
Part Number: TLV62085 Hi,
Could you please give me advice for below questions?
1. Switching Freq is decreasing from 300mA load in Vin = 2.5V as below information. Is there idea why switching freq is decreasing in only Vin = 2.5V?
2. The calculation for…
Part Number: TLV62085 Hi
Our customer are evaluating TLV62085 on their board now. They found VIN<VOUT situation at start up.
(The measured voltage between VIN and VOUT is more than 0.3V for 4ms.)
At the specification,the Max rating of SW is defined…
Part Number: TLV62085 Hi,
I would like to confirm if it is suitable to perform a EN delay through a RC filter at EN pin. The target is enable output voltage when the VIN voltage reaches at least 95%, VIN has a slow start (10ms 0V to 3,3V). I read the…