Part Number: TLV751 Tool/software:
Kindly review the design of the TLV75101PDSQR buck regulator and confirm its correctness. A block diagram is attached for your reference.
Part Number: TLV751 Other Parts Discussed in Thread: TPS7A26
Tool/software:
Hi Team,
We are using TLV751 in our design for 1P8 and 3P3 output. Among other loads already present, we are planning to power a ToF sensor part( VL53L8CXV0GC/1 ) which has the…
Part Number: TLV751 Tool/software: I'll be using the TLV751 in an application where only one of its outputs is used. I was wondering if there were any recommendations on how to connect the unused channel. My current plan is to simply ground IN2.
Part Number: TLV751 Tool/software: We are designing a dual LDO circuit for the camera module that incorporates the CMOS sensor OV5640. For this purpose, we are using the TLV751. The output requirements are 1.8V and 2.8V. V_OUT_CAM_1P8 should be enabled…
Part Number: TLV751 Hi team,
I would like to ask a question about TLV75101PDSQR. As shown in the picture below, I connected both OUT1 and OUT2 channels of TLV751 to output "FPGA_HSSTAVCCPLL_1.2V" at the same time. What I want to ask is whether I can…
Part Number: TLV751 Hello team,
I would like to ask a question about TLV75101PDSQR. As shown in the picture below, I connected both OUT1 and OUT2 channels of TLV751 to output "FPGA_HSSTAVCCPLL_1.2V" at the same time. What I want to ask is whether I can…
Part Number: TLV751 Dear Team,
we wan to use TLV751180330PDSQR for 1.8V and 3.3V
Vin = 3.4V
Vout1=1.8V Iout1= 20mA
Vout2=3.3V Iout_max=88mA Iout_typ=72mA
Would you recommend TLV751180330PDSQR for this application ( regarding dropout voltage )?
Would…
Part Number: TLV751 Hi team,
I check that The TLV751 is a dual, adjustable, 500-mA low drop out (LDO) regulator. But I am not sure if 2 channel can provide 500mA at the same time, especially when their voltage between the input and output is large. Could…
