Part Number: TLV9051 Dear Sir,
I would suggestion TLV9051IDBVR to replace Microchip_MCP6021(SOT23-5).
Could you kindly share RTM schedule.
Thanks!
Steven
Hi Marcus,
Please remove the 1uf capacitor from TLV9051 and place it to the other side across 235kohm resistor. Op amp does not like to drive capacitor because it creates additional pole in the feedback loop. Please let me know if this fixes it.
This…
Part Number: TLV9351 Other Parts Discussed in Thread: TLV9051 , TLV9151 Hi sirs,
My customer designs TLV9351 with 5Vcc at V+, and GND at V- pins. However, the input signals is 3.2V around at IN+, IN- pins. from data sheet, it requires (V+ - 2). On this…
Hi Rene,
Does your design require a 16V supply like the TLV9151 offers? If it doesn't and only requires up to a 5.5V supply, would the TLV9051 work for you?
Thank you,
Tim Claycomb
Part Number: LM321LV Other Parts Discussed in Thread: TLV9051 , OPA2992 Hi Team,
the spec of LM321LV show the Gain-bandwidth Frequency is 1MHz, but in my customer testing circuit the distorted frequency is up to 100KHz. Could you pls help provided any solution…
Hi Santosh,
the TL082 is no "rail-to-rail" OPAmp and you are violating the common mode input voltage range. You must stay 4V away from the supply voltages. Also, the minimum supply voltage of TL082 is 10V. So 5V would be way too small.
You could…
Part Number: AMC1300 Other Parts Discussed in Thread: AMC1200 , AMC1200EVM , TLV9051 , TLV6001 , TLV9061 Hi, We are using the AMC1300 as a voltage sensing circuit (grid voltage). The application is an inverter connected to the 3phase grid. It is based on two…
Okay, I think I understand. You're looking for a part to replace TL082 that can support a single ended 5V supply. A suitable replacement part that keeps the same GBW, slew rate, and is usable with a min supply of 5V is TLV9051. This keeps you in the same…
