Part Number: TLVM23625 Other Parts Discussed in Thread: TPSM33625 Hi,
we are using TLVM23625RDNR for 24V to 3V...4V constant voltage supply. We would like to reduce radiated EMC peaks at multiples of the switching frequency of the TLVM23625RDNR. Can anyone…
Part Number: TLVM23625
Hi support team, According to the original question, I understand the settings when outputting 1V as follows.
RFBT: 10kΩ RFBB: Open
However, there is no description in SNVSCI2B that makes RFBB open.
Are there any notes?
This…
Part Number: TLVM23625 I just started testing my PCB using the TLVM23625RDNR and soon discovered that a short-circuit on the output imediately kills the regulator (VCC to GND ~0.xOhm). I attached snippets of my schematic and layout below. This is a 2 Layer…
Hi Noam,
We revisited this and found that the reason the TLVM23 625EVM required an input voltage greater than 5V to operate at 5V out was due to a resistor divider network on the EVM. When R4 is populated (which it is by default), the input voltage required…
Part Number: TLVM23625 Hello,
I am using several TLVM23625 in my design.
19V input->5V output
19V input->3.3V output
19V input->1.8V output
19V input->1.2V output
19V input->1V output
5V input->3.3V output
5V input->1.8V output
5V…
Part Number: TLVM23625 Hi team,
My customer considers to use TLVM23625 for some power rails.
One of power rail is 1V, so they attempted to set Vout=1V by shorting R5, J3:short 1-2 of TLVM23625EVM in accordance with Table 8-1.
However, Vout became about…
Part Number: TLVM23625 The TLVM23625RDNR part, does this support the RT pin function for setting the switching frequency? as it is not clear on the Datasheet.
Part Number: TLVM23625 Hi
Is it possible to get a step model file of the QFN-FCMOD-11 package used for TLVM23625.
Since the footprint and pads are quite "non-standard" it would be nice to be able to verify it with a step model.
Regards
/Jo…
Part Number: TLVM23625
Hello Team,
once operating Vcc could be higher than Vin? Can you clarify, please?
Is this module ok for a Vin =3.55V +/-1% (Vin, min=3.51V and Vin,max=3.59V) and Vout=3.3V? Why is Tss specified for Vin =4.2V?
Thank you and Best…
Part Number: TLVM23625 Hi Team,
I am looking at the Land pattern example in page 48. I was a bit confused with the drawing.
I interpret the drawing as:
Gray = Copper pads
Light Green = Soldermask opening
Blue = Metal under mask
Which makes the land pattern…