Part Number: TMAG5170-Q1 Dear TI Team,
I am working on setting the magnetic range solution for TMAG5170A1 sensor.
What results do I achieve when the setting is done as figure 1 compared to figure 2 (yellow marked)?
Could the setting be carried out as…
Part Number: TMAG5170 Tool/software: Hi,
what does "0h = Conversion start at SPI command" mean in Table 7-8 (Trigger Mode)? How to implement "conversion start at SPI command"?
does it mean that if Trigger Mode is "0h", to trigger…
Part Number: TMAG5170-Q1 Other Parts Discussed in Thread: TMAG5170 Hi Team,
We are using the TMAG5170-Q1, We are able to get the sensor data when the sensor is operating in DEVICE_CONFIG_OPERATING_MODE_ActiveMeasureMode.
my application demands data only…
Part Number: TMAG5170-Q1 Other Parts Discussed in Thread: TMAG5170 Hi, TI team
Does the 3D hall sensor TMAG5170-Q1 support the following application?
is there any difference compare to the on shaft application, like the angle accuracy?
below is the on…
Part Number: TMAG5170 Hi,
Tmag5170 gives possibilty to check internal oscillators via osc_monitor and test_config.
In test config I can choose hfosc or lfosc.
Is high frequency and low frequency oscillators working in Configuration Mode and Stand-by Mode…
Part Number: TMAG5170-Q1 When reading out the TEST_CONFIG register for the A1 variant we get the value 2h (Reserved) for the VER field (bit 4-5). The expected value is 0h (A1 rev). When doing the same readout for the A2 variant we get the expected 1h …
Part Number: TMAG5170 Hello:
The angle obtained in TMAG5170 has a large speed burr after differentiation. The schematic diagram is as follows. What are the reasons for this problem? Is there any corresponding solution?Thanks!!!
Dear,
I am working on TMAG5170A1EDGKRQ1 sensor (register setting range ±25mT), but changed to TMAG5170A2EDGKRQ1 (register setting range ±75mT). Can you assist with magnetic sensor output calculation data to know the tolerances and accuracies (See attached…
Part Number: TMAG5170 Hi,
We are planning to use TMAG5170A2 to autowakeup when a magnetic threshold is reached and then wakeup a BLE controller.
But is it possible to then update the threshold to a higher value and go back to auto wakeup mode? If so what…