Part Number: TMAG5170-Q1 Hello,
I would like to use the TMAG5170A1EDGKRQ1 in trigger mode. The ALERT pin is used as the trigger.
I have set everything as described in the data sheet, but no measurement is being performed. When I read out the measured…
Part Number: TMAG5170-Q1 Tool/software: Hello,
I need to use the magnetic sensors in a magnetic field leakage (MFL) application where the sensors are assembled between the legs of a strong permanent horseshoe magnet. I have the following two questions…
Part Number: TMAG5170D-Q1 Other Parts Discussed in Thread: TMAG5170 , TMAG5170-Q1 Tool/software: Dear Technical Support Team,
What's the difference between TMAG5170D-Q1 and TMAG5170?
TMAG5170D-Q1 has a dual die version, could you share the advantage…
Part Number: TMAG5170-Q1 Tool/software: Hi Teams:
When I debug my code, there are only X channel output the data, the commands as follow:
Disable the CRC: 0x0F00 0407
Config Device: 0x00512000
Config Sensor: 0x0141EA00 //x,y,z mode
config…
Part Number: TMAG5170-Q1 Tool/software: Hi Experts,
Good day!
Customer want to use the TMAG5170-Q1 in an electric cooling valve driven by an axial flux pmsm. For absolut angle messurement with 0.5° precision. I cant find any specific information…
Part Number: TMAG5170-Q1 Dear TI Team,
I am working on setting the magnetic range solution for TMAG5170A1 sensor.
What results do I achieve when the setting is done as figure 1 compared to figure 2 (yellow marked)?
Could the setting be carried out…
Part Number: TMAG5170-Q1 Please confirm our understanding of the CRC:
For a regular register read, if the CRC sent to the chip is incorrect, the chip inverts the LSBit of the CRC in the response data. The response data is present, but the CRC miss…
Part Number: TMAG5170-Q1 Other Parts Discussed in Thread: TMAG5170 Hi, TI team
Does the 3D hall sensor TMAG5170-Q1 support the following application?
is there any difference compare to the on shaft application, like the angle accuracy?
below…
Part Number: TMAG5170-Q1 Other Parts Discussed in Thread: TMAG5170 Hi,
The MISO(SDO) pin of TMAG5170-Q1 always keeps low. I have checked each pin and no pins are shorted each other. I have captured the signals of each pin. The figure is in the following…
Part Number: TMAG5170-Q1 Hello team,
What is the mechanical tolerance for the Hall sensor position inside of TMAG5170-Q1? X, Y and Z?
Best regards, Antoine
