Part Number: TMAG6180-Q1 I have been working with the TMAG6180-Q1 AMR sensor for angle measurements. I noticed that in the sensor’s datasheet, the COS_P signal leads the SIN_P signal when a magnet is rotated counter-clockwise above the sensor. This behavior…
Part Number: TMAG6180-Q1 Other Parts Discussed in Thread: TMAG6180 Hi team,
My customer is using TMAG6180 for testing. There is an issue that the output voltage reaches 4.7V with 5V VCC.
What potential factors may cause this issue?
For layout convenience…
Part Number: TMAG6180-Q1 Hi team,
I have a question about Angular performance spec in the datasheet 5.6 magnetic characteristic.
ANG ERR_DYN_DE = Angular error linearity across temperature on continuous calibration(gain/offset)
Does this "continuous…
Part Number: TMAG6180-Q1 Dear Experts
I would like to inquire about issues related to TMAG6180-Q1.When using the TMAG6180-Q1, the customer noticed significant fluctuations in the SIN differential signal output compared to the COS signal. Previously…
Part Number: TMAG6180-Q1 Tool/software: Is it an :"absolute sensor":
The component suits me for two main reasons: 0.4 degree accuracy and a 360 degree range.
What bothers me is that it is not stated that the measurement is absolute at waking up. …
Part Number: TMAG6180-Q1 Sensor team,
On page 24 of the datasheet, Figure 7-2, you'll notice that the note numbers, eg. (1), (2), don't match the net name being reference in the picture. Can you clarify which note goes with which resistor?
Thanks…
Part Number: TMAG6180-Q1 Tool/software: Hi all,
Can TMAG6180-Q1 be installed horizontally? Are there any corresponding cases? My customer LINGXIANG is going to use it in a new project and now wants to know whether it can be installed horizontally…
Hi Scott
I understood that SLAU839 is sensor control board which can be used evaluation of TMAG6180-Q1 & TMAG5170-Q1.While going through abstract section, i got little confused on the "software updates". Does this "software updates" referring to MSP432E401YTPDTR…
Part Number: TMAG6180-Q1 Other Parts Discussed in Thread: DRV5055 Tool/software: Hello,
I would like to know if it is advisable to operate the TMAG6180-Q1 with a single diametric magnet in an application where the magnet can move approximately 30mm…
Part Number: TMAG6180-Q1 Tool/software: Hi team,
Do you have any test results on the delay time of the output signal Q0 relative to sin/cos? I don't see this value in the datasheet.
Best Regards,
Jade Lan
