Part Number: TMDSCNCD28388D Other Parts Discussed in Thread: C2000WARE , Imported CCS lab Project from C2000 ware as per this directory C2000Ware_5_00_00_00/training/device/f2838x/control_peripherals/lab_eqep.
This project is successfully building but not…
Part Number: TMDSCNCD28388D Other Parts Discussed in Thread: CONTROLSUITE , C2000WARE
Hi,
I have some problems with the project that I have in CCS. Could you help me to fix that?
Best wishes,
Milad
Part Number: TMDSCNCD28388D we have a SSI absolute optical encoder of 22 bit resolution single turn encoder, to read data from this encoder on to TMDSCNCD28388D, clock sequence to be generated with 23 clock pulses of frequency 100KHz and with delay of…
Part Number: TMDSCNCD28388D Other Parts Discussed in Thread: TMS320F28388D Hi all!
I have a problem relating to the cla_ex4_pwm_control example for the TMS320F28388D. After loading and running the program multiple times, I sometimes I get no PWM output…
Hi,
After building the CM project, you need not launch the debug session again. You can just load the binary to the CM core and then run it.
Best Regards
Siddharth
Part Number: TMDSCNCD28388D I managed to find:
https://www.ti.com/lit/pdf/spru430
It apparently was last updated in 2015. Is this the best resource for an instruction set ref.
Thanks.
Part Number: TMDSCNCD28388D Hi Team,
My customer executed read operation to 0x100000 to 0x100009 part. But he found that the address bus A0's status changed from 0 to1 need two read operations. What is the reason?
Here are his configurations, The data…
Part Number: TMDSCNCD28388D I use the official development board for EtherCAT debugging. After downloading the official routine f2838x_cm_cia402_solution, sometimes EtherCAT can connect normally. Sometimes it cannot be connected (even if it is the same…
Part Number: TMDSCNCD28388D Hi,
I hope my email finds you well.
I am a student at the University of Texas at Dallas.
I have bought a TMDSCNCD28388D control card and I am working with it. I am interested to implement a motor control for a 3 phase motor…
Hi Makoto,
If you refer to the TMDSCNCD28388D schematics, clock to the F28388D can be derived either from Y1 (25MHz after the buffer U5) or Y2 (20MHz) depending on R39/R43 0ohm connection. Y1 and Y2 are crystal oscillators. Crystal oscillators require…