Other Parts Discussed in Thread: TMDSDOCK28M36 , CONTROLSUITE I've got a customer using a project based on the F28M36; I have a TI Control Card (TMDSDOCK28M36) with, I believe a TMDSCNCD28M36. When we power up the TI ControlCard, the system boots properly…
Hi, Please note that EtherCAT is not exactly Ethernet. EtherCAT is an ethernet-based Industrial Fieldbus standard. Note that the ET1100 in the TI Design is not able to rx/tx standard Ethernet frames (because there is no Ethernet MAC in that chip). I haven…
Hi Sanjana, What hardware are you using? If you're using a TMDSDOCK28M36 or TMDSCNCD28M36, please take a look at this controlCARD infosheet. It can be found at the below path within controlSUITE: \controlSUITE\development_kits\~controlCARDs\TMDSCNCD28M36_v1_3…
Hi Israel, 1) In many of C2000's kits, we use a FT2232D or FT2232H to convert USB from a host PC to JTAG and also USB to UART/SCI. That chip has two parallel paths and both can be utilized - and we often do in our kits. JTAG should only be used for programming…
Hi Arno, Based on what I understand, you are now waiting on an emulator before continuing with the debug of your custom board. You are now attempting to connect a XDS510USB emulator to the F28M36x development board (TMDSDOCK28M36) in order to gain some…
Hi Chaithra, 1) The errata document is correct for all standalone sold chips. The TMDXCNCD28379D kits were built with silicon that would have been earmarked for in-house use (but tested and handled appropriately) - Rev C and TMX. Because of the delay…
To all, Attached is the next version (v1.2) of the F28M36x Infosheet document which will get put into controlSUITE in the near future. I've attached it here in order to help those that are confused and find this post. Hopefully, this helps to clear up…
