Hi, Gus :
Thank you very much for your feedbacks.
My problem is solved. I am thankful to you.
Gus Martinez said: Could it be that you are not triggering your oscilloscope or logic analyzer correctly?
The problem is caused by the incorrect my oscilloscope…
Part Number: TMDSECATCNCD379D Other Parts Discussed in Thread: C2000WARE Hello,
I am getting the error in the picture below when I loading a program on FLASH. I could not resolve the this error. What do you think could be the cause of this error?
…
Part Number: TMDSECATCNCD379D Hi,
The expression 'identifier not found: sdata' appears when I want to watch variables values in my program. How we can solve this problem?
I am using CCS version 9.3.0.00012.
Sinan, Thanks.
Part Number: TMDSECATCNCD379D Other Parts Discussed in Thread: C2000WARE Hi,
I am using the example below. I did not make any changes in this example.
C:\ti\c2000\C2000Ware_3_04_00_00\device_support\f2837xd\examples\dual\cpu01_to_cpu02_ipcdrivers
The…
Sinan,
If you want to use the ipc driver, then integrate the two projects, and make incremental change so that you can check if it continue to work. and narrow the issue if it fails.
If you have not gone through, you can take a look at online workshop…
Part Number: TMDSECATCNCD379D Hi, Good day. Our customer would like to know the maximum current draw of this card. It seems this information is not available in documents. They are designing a power supply for this. Thank you for your help. Regards, Ced…
Part Number: TMDSECATCNCD379D Hi:
I have problems in my EtherCAT project. My EtherCAT device (ET1100) is in OP mode as "Current State" in configuration mode in TwinCAT software. However, when I set the "Activate Configuration" in TwinCAT software, the…
Part Number: TMDSECATCNCD379D Other Parts Discussed in Thread: CONTROLSUITE Hi there,
Based on TMDSECATCNCD379D we have developed our own servo motor slave. But regarding the network stability we don't know how to analyze. We look into ET1100 error counter…
Part Number: TMDSECATCNCD379D Other Parts Discussed in Thread: C2000WARE , TMDSCNCD28388D
Hi there,
In DP83822 manual (SNLS505C), it is stated that pin 13 and 15 should be left floating while pin 24 should be connected to a pull-up/down resistor:
But…