Hi Mr. Liu For the second question, I have got the point that (load addr: 0x82000000 -> 0x80800000) modification is not good. Thank you for your help.
Regards.
Part Number: TMDSSK3358
Hello, customer want to test 3x UART, 1x USB, 1x Ethernet on the TMDSSK3358 EVM. Is this possible?
UART0: used by USB to UART chip (FT2232HL)
UART1: pins used Wifi module
UART2: pins for Zigbee header
Are these signals available…
Part Number: TMDSSK3358 There is this workaround in spruih9.pdf .
How did you implement this workaround ? Is this "rgmii-id" in "$kernel/arch/arm/boot/dts/am335x-evmsk.dts" for the purpose of this workaround ?
Part Number: TMDSSK3358
To anyone concerned
Hello, I'm using TMDSSK3358 board and trying to boot up Linux Kernel through USB port or ethernet only. That means I have to put the rootfs on memory, using a ramdisk or the zImage.
I have two questions here…
Part Number: TMDSSK3358 Other Parts Discussed in Thread: UNIFLASH I tried USB boot, but failed. Firstly, I pressed power on button of TMDSSK3358 without micro SD card. Secondary, I pressed Start Flashing button of UniFlash. (Fig.1) Then, BOOTP and TFTP packets…
Part Number: TMDSSK3358 In the parent thread, I'm investigating USB boot problem. But, it seemed that watchdog reset was occurred during suspending at breakpoint in SPL bootloader. Therefore, it's difficult to investigate some register or memory.…
Part Number: TMDSSK3358 hello Team,
I downloaded layout tmdssk3358 related design files from following link
TMDSSK3358 Evaluation board | TI.com
Here the layout and schematic are not matching .
I got below link for the old schematic
https://e2e.ti.com…
Part Number: TMDSSK3358 According to 3.5.1 Boot Configuration in spruih9.pdf, The default settings for the TMDSSK3358 is 01_00XX_XXXX_XX11_0111b. This corresponds to a boot sequence of: . MMC0 . SPI0 . UART0 . USB0
Could you please teach me how to boot from…
Part Number: TMDSSK3358 In the parent thread, I posted that I can't use gdbserver and CCS.
In this thread, I tried Remote-System-Explore using ssh as follows.
But I got this error as follows. (I used tisdk-default-image-am335x-evm.tar.xz in the latest…
Part Number: TMDSSK3358 I tried to connect the target board TMDSSK3358 via JTAG on VirtualBox. But it took more than ten minutes to connect. During connecting, OnTargetConnection() message was displayed as shown in Fig.1 . After connecting, CCS response…