Part Number: TMP102 As specified in the TMP102_cn.pdf document, the configuration register is shown below:
To place the TMP102 into Shutdown Mode and conserve more power for the product, the SD bit is set to 1. When temperature data is required,…
Part Number: TMP102 Other Parts Discussed in Thread: HDC3020 Please suggest a temperature and humidity sensor IC equivalent to the TMP102AQDRLRQ1 , where a single IC supports both temperature and humidity measurement . Kindly recommend the best part number…
Part Number: TMP102
Assumptions: F1/F0=0b00; Alert Pin in Interrupt mode
In the TMP102 datasheet, diagram (page 18; Figure 6-7), in 2nd temperature zone, when the temperature dips below the high limit and it goes back up above the high limit; the…
Part Number: TMP102 Other Parts Discussed in Thread: CC1310 Dear Experts,
The customer is using TMP102 for temperature measurement applications and is currently conducting power consumption tests on the same board. It was found that the latest batch…
Part Number: TMP102 Hello,
Does TI have data demonstrating reliability of the NiPdAuAg finish compared to the NiPdAu finish paper published by TI (SZZA031): "A Nickel-Palladium-Gold Integrated Circuit Lead Finish and Its Potential for Solder-Joint Embrittlement…
Part Number: TMP102-Q1 Other Parts Discussed in Thread: TMP112-Q1 , TMP102 Tool/software: Hello:
The specification sheet of TMP102-Q1 shows the accuracy without calibration. May I ask how much accuracy can be achieved after calibration? Additionally…
Part Number: TMP102 Tool/software: Hi Team
Regarding the bypass capacitor for the TMP102, the data sheet recommends 0.01uF, but would 0.1uF be okay?
Also, is the recommendation of 0.01uF based on the frequency characteristics of the capacitor?
Best…
Part Number: TMP112 Other Parts Discussed in Thread: TMP102 ,
Do TMP102 and TMP112 support I2C clock stretching? If yes, could you describe how it is implemented internally?
Under what conditions would clock stretching be triggered? For example…
Part Number: TMP102 Die Bauteile wurden mit Kunststoffgrat geliefert. Die Bauteile benetzen nicht gut und haben teilweise Brücken. Die unsere Sichtprüfung manuell nachlöten muss. Hier entsteht uns ein Mehraufwand, den wir später nachreichen werden.
…
Part Number: TMP102 Other Parts Discussed in Thread: TMP112EVM , TMP112 Hi team,
My customer is considering TMP102.
What is the recommended EVM for TMP102?
Should it be TMP112EVM?
Is there any modification needed to evaluate TMP102 on TMP112EVM…
