Search tips
Showing 28 results View by: Thread Post Sort by

  • TMP118: TMP118 Temperature outliers

    Part Number: TMP118 Sensor: TMP118MBIYMSR SCL operating frequency: 100kHz Config: continuous conversion mode (1Hz), 8x back-to-back averaging. (writing 0x6078 to the register) The sensor is configured once on startup. The config register is read back…
    • Answered

  • TMP118: Datasheet Questions TMP118

    Resolved
    Part Number: TMP118 Dear Support Team I have the following questions regarding datasheet information of the TI TMP118: Table 4-2 specifies 0.05 °C typical accuracy between 0 - 45 °C. On the other hand, chapter 6.5 only specifies the 0.05°C accuracy…
    • Resolved

  • TMP118: PS voltage for TMP118 and PS for Pullup resistors

    TI Thinks Resolved
    Part Number: TMP118 Hello Are the I²C pins (SDA, SCL) of the TMP118 overvoltage tolerant, allowing pull-up to 3.3 V when VDD is 2.5 V? Thanks in advance, Michael

  • TMP118: Drive strength of TMP118 and TMP117

    TI Thinks Resolved
    Part Number: TMP118 Other Parts Discussed in Thread: TMP117 Hi team, I was wondering about any potential side effects of drawing 3.3mA of output current from the TMP118. The datasheet recommends a max of 2mA, so I'm guessing it's not recommended but…
    • Answered

  • TMP118: TMP118 v TMP117 Strain Tolerance

    Resolved
    Part Number: TMP118 Other Parts Discussed in Thread: TMP117 , Hi Team, Noticed that the TMP118 datasheet talks about strain tolerance when placed on a PCB in section 7.3.4. Is this also relevant and/or characterized for TMP117? Best, Jake
    • Resolved

  • TMP118: TMP118 Pinmap Check Request

    TI Thinks Resolved
    Part Number: TMP118 Tool/software: Attached is a picture of the floor surface of TMP118. Please check the pin map.
    • Answered

  • TMP118: Pull-up voltage

    Resolved
    Part Number: TMP118 Can the SDA and SCL lines of the TMP118 be pull-up to a voltage higher than VDD. For example I have a VDD of +1V8 and want to pull the I2C lines to the +3V3.
    • Resolved
    • Answered

  • TMP118: Incorrect Read of NIST ID (Unique ID).

    Resolved
    Part Number: TMP118 Hello TI, I'm having an intermittent issue reading the NIST ID from TMP118 Sensors. Most reads complete successfully, but occasionally I receive incorrect data from the sensor. I've attached a screen-shot of the read sequence during…
    • Resolved

  • TMP118: TMP118 C and D versions continue to show "Out of Stock"

    TI Thinks Resolved
    Part Number: TMP118 Tool/software: Hi Harry, Following up on our previous discussion from last week, the TMP118 C and D versions continue to show "Out of Stock" on the the TI website (same for A and B versions on the website as well!). This is reflected…
    • Answered

  • TMP118: Per Device specific Calibration Certificate

    Resolved
    Part Number: TMP118 Other Parts Discussed in Thread: TMP117 , For the TMP118, and I assume TMP117, where level 1A device trackign is available, is it possible to generate a per device NIST compliant calibration certificate. That would typically include…
    • Resolved

Didn't find what you are looking for? Post a new question.