Part Number: TMP175-Q1 Tool/software: Hello Application teams:
we try to set TMP175-Q1 expect the resolution of data0 temperature should be changed to "12 bits" after issued 0x72 to configuration register 0x01 . See below register setting .
But the…
Part Number: TMP175-Q1 Facing issue while writing configuration register with 9 bit resolution (R0,R1 bit) using I2C protocol. Whenever trying to write the configuration register with 9,10 or 11 bit resolution it is always considering 12 bit resolution…
Part Number: TMP175-Q1 Hi team,
Could you help to confirm which pin is Pin 1 of TMP175AQDRQ1?
According to datasheet, there should be a dot on the case, however, there is a dash on the case of the real chip. Based on my experience, the pin in red…
Part Number: TMP175-Q1 Hi,
I am designing a PCB where I will be connecting several temperature sensors TMP175-Q1 using I2C interface to the MCU. I have three questions in regards to this: 1) I have read that the maximum number of devices that can be…
Hi,
Thanks for posting to the Sensors forum.
Calibration is not required for the TMP175-Q1. You can find the accuracy specification in Section 6.5 of the datasheet .
Best regards,
Jesse
Hi Alpha,
Here is a complete list of our Automotive, I2C, temperature sensors. Most of them are AEC-Q100 Grade 1 or higher, which will meet your requirement. Many also have an alert function like you are describing.
I would recommend the TMP112-Q1…
Part Number: TMP175 Hi team,
Could you support following question please?
[Q1] Does this device support Bus Clear as defined in the I2C bus specification? Also, does the bus clear process initialize the registers?
[Q2] Are the registers initialized…
Part Number: TMP175 Hi team,
I have question about timing diagram (Fig.7-4 in D/S).
[Q1] Data transfer is terminated by ACK by Master. On the other hand it is said that "On a master receive, the termination of the data transfer can be signaled by…
Hi Sudheer,
Thanks for addressing the issue. After changing HOST_PORT_VLAN_ID from 1 to 10 (unused VLAN), we were able to successfully ping from the target's main interface (eth0) to the host.
I have a couple of questions:
Q1) When loading the…
