Part Number: TMP411-Q1 Other Parts Discussed in Thread: TMP411 Hi team,
What's the difference between TMP411-Q1 and TMP411ADGKR
1. Can pin to pin be replaced directly without changing the layout?
2. What is the difference between the two? Does customer…
Part Number: TMP411 Hello team,
I received 2 questions from the customer.
1. Which of the following is the value read from the local temperature and remote temperature registers when the BUSY bit is ON (1)? Discarded as an undefined value or Previous value…
Part Number: TMP411 Hello,
It looks like the differences are primarily the binary address and the hex address parameters. Question….are these parts all made from the same die, and configured (programed) at the final stage, or are they unique die for each…
Part Number: TMP411 Hi,
I want to read the data continuously through the tmp411 sensor.
I just set temperature range bit to 1 and RES0, RES1 to 0.
But, always read "1" from the SD bit in the Configuration register.
If i read back the configuration…
Part Number: TMP411 Other Parts Discussed in Thread: TMP127 Hi team,
Customer is looking for Local & Remote temperature monitor but with SPI interface.
but our TMP411(I2C) can' support SPI.
TMP411(I2C): Local & Remote (come from DMD internal thermal…
Part Number: TMP411-Q1 Other Parts Discussed in Thread: TMP411 Hi Sensor Team,
I have some questions about "series resistance cancellation" as shown in TMP411 datasheet. Basic Connections of TMP411 is shown below.
Q1: How to understand "…
Part Number: TMP411-Q1 Other Parts Discussed in Thread: TMP411 Hi Sensor Team,
From datasheet, I understand that Rs and Cdiff can minimize noise found in the end equipment.
Is there a formula or way to calculates a specific value?
Thank you very much.
…
Part Number: TMP411 Hi team,
Can PIN5 be directly grounded? Or do I need to connect the terminal of the bypass capacitor first, and then connect to ground as shown in the SPEC? Are there any requirements for this part?
Part Number: TMP411-Q1 Other Parts Discussed in Thread: TMP411 , Hi Experts,
My customer want to know the minimum time from TMP411 power up to read back the first temperature data. Do you know how to calculate it?
How to understand the conversion rate? If…