Part Number: TMP464 Hi TI team
We are using TMP464 in an application where D1 is not used and hence connected to D- as indicated in the datasheet
the strange thing is that with this configuration, we detect a short circuit to GND on both these pins…
Part Number: TMP464 Hi team,
My customer is considering to use the TMP464. Could you please help with the questions below?
1. Is the T_REMOTE listed in the datasheet the ADC accuracy of the TMP464 itself?
2. There is a formula for calculating T_ERR when…
Part Number: TMP464
T_ERRはT_REMOTEとは別で発生する誤差であると理解しました。
T_ERRで使用するN-factorは、N-factor Correction Registerの影響を受けますか?
適切なNファクターをRemote temp 1 η-factor correctionへ書き込めば、T_ERRは小さくなりますか?
I understand that T_ERR is a separate error from T_REMOTE.
Is the…
Part Number: TMP464 Other Parts Discussed in Thread: TMP435 , TMP411 , TMP401 , TMP431 , TMP432 , TMP461 , TMP442 , TMP421 , TMP423 , TMP422 , TMP441 Hi Team, Our customer would like to confirm if TMP464 supports Linux kernel and its device tree entry.
Please refer…
Part Number: TMP464 Hi sir,
Could you help to check if transistor PMBT2369 is suitable to use as remote temperature sensing BJT for TMP464?
Thank you.
PMBT2369.pdf
Part Number: TMP464 Other Parts Discussed in Thread: TCA9548A , Hello,
a customer sent the following:
The TCA9548A does not specify to which NET should I connect the thermal pad, only I “ The package thermal pad must be soldered to the printed circuit…
Part Number: TMP464 Hi,
I have a qusetion about sense remote temperature by TMP464.
The pin function defines negative connection to remote temperature sensors and common for 4 remote channels.
Can we read the tempearture from 4 remote channels in the…
Part Number: TMP464 Dear TI E2E team,
We use a TMP464 on our board and for software purpose we have to check the TMP464 Device ID though the two-wire bus.
On our board, device ID read at address FFh is 0x1468.
This value is unexpected : device ID should…
Part Number: TMP464 hi Team,
my customer uses TMP464 channel D1/3/4 for measuring remote temperature but they only want THERM pin report the over temperature warning on channel D1/3 and the warning of D4 needed to be ignored.
so how can we achieve this…
Part Number: TMP464 The datasheet parametric table for TMP464 doesn't specify a recommended max pull-up voltage for the _THERMx outputs.
The pin functions table alludes to a limit of 3.6V, but this is far, far below abs,max = 6V for this pin.
Customer…