Part Number: TMP75
Tool/software:
The chip communicates with the CPU through the IIC bus, and the bus transmission rate is 100Kbit/s. According to the requirements of the CPU data sheet, the maximum data output delay time(tI2OVKL) during write operations…
Part Number: TMP75 Tool/software: Hi Team, Is there any difference between TMP75AIDR & TMP75AIDRG4? The only diff is that "G4" version is the PB-Free version. The functionality should be same. am i right?
Part Number: TMP75 Tool/software: Hello,
We have a quick question on the TMP75. It's been seen that when TMP75 is installed into a system, but not powered, the SDA line rises up to 3.3V for the host. While this is expected and favorable, it is somewhat…
Part Number: TMP75 Tool/software: hi there
We are using two TI TMP75AIDR shared the same SMbus line see below.
Alert pin is not used and do not have external pull high.
My question is if there is no external pull high on alert pin, what are the…
Part Number: TMP75-Q1 Other Parts Discussed in Thread: TMP75 , TMP110 , TMP1075 Tool/software: hello there,
I want to confirm the supply voltage for TMP75_Q1 component, and it can be found in datasheet, that is from 2.7V to 5.5V. But the confuse is…
Part Number: TMP75 Tool/software: Hello,
I am trying to interface TMP75 temperature sensor.
I am using NXP S32k312 mcu using Model Based Design toolbox.
From your forum,I saw following should be the waveform for continuous conversion
But I am…
Part Number: TMP75 Tool/software: If the TMP75 holds the SDA line low,
will the TMP75 always release the SDA line within 9 SCL clocks sent by the master?
Part Number: TMP75 Other Parts Discussed in Thread: TMP1075 , Tool/software: Hi team,
My customer is looking for reading back Device ID/ Vendor ID, do we have such infomation to share and readback?
Please see below example capture from other IC datasheet…
