Part Number: TMP75-Q1 Hello team, my customer is using the TMP75-Q1 and would like to understand the timing between the temperature crossing the threshold and the output on the Alert pin. Thanks for your help.
Part Number: TMP75-Q1 Other Parts Discussed in Thread: TMP75 , TCA9548A ==========
open new case, because pervious one closed by incorrect operation
all message are copy from pervious ticket
==========
Part Number: TMP75-Q1 Other Parts Discussed in Thread: TMP75 , TCA9548A Dear,
In our design(diagram below), we have 2 TMP75-Q1 and one sensor with PEC(Packet Error Checking) function support.
When we write 0x94 value data(PEC enabled) to the 0x03 register…
Part Number: TMP75-Q1 Other Parts Discussed in Thread: TMP75B , TMP1075 Hi Sir,
May I know if we have MCU driver(SMT32 or Infineon) for TMP75-Q1?
I only see linux driver in product folder.
Thank you.
Regards,
Allen
Part Number: TMP75-Q1 Hi TI expert
I looked the datasheet and it was unmarked ADAS information,please tell me whether TMP75AQDGKRQ1 is used for ADAS application and ADAS products (QM/A/B/C/D) is QM?
Thanks
Jacob
Part Number: TMP75-Q1 Other Parts Discussed in Thread: TMP75 Hi, we are using a couple of TI temperature sensors, e.g. TMP75AQDGKRQ1, for a safety critical design. I currently investigate how far soft errors in the configuration registers of such devices…
Part Number: TMP75B-Q1 Other Parts Discussed in Thread: TMP100-Q1 , TMP75-Q1 Hi team,
It is described in TMP100-Q1 datasheet as below that General call reset is required if supply voltage
is not sure to be <0.3V.
#1. Does it also apply for TMP75-Q1 device…
Part Number: TMP75-Q1 Hi TI-team
The datasheet states that the VIH is 0.7 (V+) to 6V.
6V:Why would it be a higher voltage than V+? (V+=2.7 to 5.5V)
What does it mean to be 0.7(V+) ?
I can understand 0.7, but I don't understand 0.7 (V+).
Best Regards…
Part Number: TMP75-Q1 Other Parts Discussed in Thread: TMP75 Hello everyone,
I am using TMp75 sensor for real time temperature monitoring, I configured interrupt alert. it works fine.
But i have a doubt how to send the SM_BUS command to the sensor ?
i2c_write…
