Part Number: TMS320F280049C-Q1 Hi Champ,
From datasheet , the maximum input voltage is -0.3V to 4.6V.
Customer want to know for below input signal case , any risk that this GPIO pin will be damaged?
Maximum 4.67V, minimum is -1.12V, the overshoot time…
Part Number: TMS320F280049C-Q1 Dear champs,
I am asking this for our customer.
The user wants to implement 2-phase interleaved boost with peak current mode and slope compensation.
Can the user use PWM4A/PWM5A and CMP1/CMP2 ((PWM4A(SYNCO)=>CMP1(RAMP…
Part Number: TMS320F280049C-Q1 I'm currently building a board around the TMS320F280049C-Q1 and I'm looking for a reference hardware design for the JTAG header using the compact TI 20-pin.
This is using the XDS110 debug probe. The compact TI 20…
Part Number: TMS320F280049C-Q1 Other Parts Discussed in Thread: TMS320F280049C , TLIN1021DEVM , SYSCONFIG Hi Champs,
Customer uses TI - LAUNCHXL -F280049C (TMS320F280049C)
For the particular series they are implementing the LIN/SCI Slave driver. While testing…
Part Number: TMS320F280049C-Q1 Hello TI-Support Team,
the LIN is running in slave mode and I have been using the information from the posts:
Link 1
Link 2
to set the IDSLAVEBYTE; RXMASK and TXMASK with this calculation:
Only the ID 0x1 and 0x2 should…
Part Number: TMS320F280049C-Q1 Other Parts Discussed in Thread: TMS320F280049C , TMS320F280039C Dear TI expert,
At my project, TI C2000 TMS320F280049C is used to control the digital power supply.
The output voltage will feedback into C2000 internal…
Part Number: TMS320F280049C-Q1 Dear,
280049 When the PWM output is controlled, the output is normal when the frequency is raised, and cannot be output when the frequency is lowered, and the frequency is not fixed when there is no output.
Please refer…
Part Number: TMS320F280049C-Q1
SW Team,
I'm trying to put together a library I can hand to people so they can write custom code for my device. To this end, I've put together a library project which just compiles all the sources from my main application…
sagar yadav1 said: Inject a fixed current on d-axis to force the rotor align to the zero angle position.-- Can you elaborate on the same
You can find the example code in the lab. Just insert the a current on the d-axis, and set the angle to zero for i-park…