Terrell,
Terrell Yang said: I have found and solved the cause of the frame error
What was the issue?
Terrell Yang said: when FE bit is set, the RXRDY bit in the SCIRXST register will not be set one again
I will consult with our design team and provide an update…
Part Number: TMS320F28023 Hi,
1. Do you have FMEA, FMEDA documents for TMS320F28023PTS?
2. Please tell us the presumed factors and countermeasures for the short circuit between VDDA (11pin) and VSSA (12pin) of TMS320F28023PTS. I would like to know the…
Part Number: TIDA-080004 Other Parts Discussed in Thread: TMS320F28023 , Hi Team,
I ask this from our customer.
Customer is testing the TIDM-080004, by controlling the S9KEAZ128AMLHf, using SPI signal to send commands to TMS320F28023, such as backlight adjustment…
Part Number: TMS320F28023 Other Parts Discussed in Thread: SFRA , CONTROLSUITE Hello, can customer migrate the SFRA lib on the F28023? Is the memory size ok? Is floating point needed?
Do you have an app note if customer can't use the SFRA and have to measure…
Part Number: TMS320F28023 Hello Sir,
One of my solar inverter customers is using TMS320F28023PTT. When my customer did aging test, after 5mins to 20mins, there is no PWM output and the IO output only shows in high voltage level or only shows in low voltage…
Part Number: TMS320F28023 Other Parts Discussed in Thread: C2000WARE Tool/software: Code Composer Studio Good morning,
I'm a master's student at the University of Oviedo. I am developing a project based on the simulation in Proteus of the communication…
Part Number: TMS320F28023 Hi Team,
My customer used F28023, and now reported an issue that the device couldn't run while using external crystal(X1/X2 Pin), while increased the delay time in XtalOscSel() prototype, the F28023 could run, decreased the…
Hello Wang Libo,
You can read the following from page 11.
Data is written and clocked out of the SPISOMI output on the falling edge of SPICLK from the Piccolo TMS320F28023 to the Host.
Data is read and latched at the SPISIMO input on the rising edge…