Part Number: TMS320F28032 Hi Experts,
I am asking for my customer here.
Customer are encountering the AQCSFRC cannot pull EPWMxA low.
They use S/W to write "0x1" to AQCSFRC.CSFA on EPWM1, EPWM2, EPWM3, and find that only EPWM2 cannot pull EPWM2A…
Part Number: TMS320F28032-Q1 Hi BU experts,
In customer side, already found 2 pcs F28032 CSM unexpectedly locked. They don't use CSM to lock the device, however still found 2 pcs from their field returned with OTA failure and they found that the 2 return…
Part Number: TMS320F28032 Hi Team,
When TBCTR is incrementing in up-down count mode, why CBD and CAD event can happen? And CBU&CAU for decrementing.
--
Thanks & Regards
Yale
Part Number: TMS320F28032 Hi Experts，
I am asking for the customers.
Could we where the chip code runs when we run the project without connect to the target in debug mode?
Th customers are facing a condition that they couldn't always connect to…
Part Number: TMS320F28032 Hi Every one,
I know the f or normal device operation(debugger not connected) TRSTn needs to remain "low", it recommend placing a 2.2kOhm pull-down on this pin hold the test logic in reset.
But m y customers' TRSTn pin resistance…
Part Number: TMS320F28032 Hi ,
When ever my input to ADC exceed 3.0V, the output I read is 0 volt.
other wise it the input to ADC is less then 3 Volt, i am getting proper output from software.
IS there any setting or changes we need to do to get…
Part Number: TMS320F28032 Hi Experts,
I am asking for my customer here.
How to assign _epilog_c28x_ to a user-defined flash address?
By default, _epilog_c28x_2 is assigned to .text, and this .text program segment belongs to the FLASH area, But when…
Part Number: TMS320F28032 Hello,
If WDFLAG=1 it means reset type is watchdog. But we read WDFLAG=1 even power on reset condition. What can be the reason for this?
How can I understand reset type of micro? Either its BOR or watchdog reset? The only…
Part Number: TMS320F28032 We are using 10 Ohm series resistor for XRST, TDO, TDI, TMRS and 3V3 between XDS100v2 programming tool and MCU.
We did not use any pull-up resistor for JTAG programming pins.
What is your recommendation for JTAG connection…
Part Number: TMS320F28032
What happens to XRS pin during BOR reset condition?
In normally if WD reset occurs this pin held low for 512 OSCCLK and WDFlag is set.
If BOR reset occurs what time XRS pin is held low and WD flag is still set or not…
