Part Number: TMS320F28034-Q1 Other Parts Discussed in Thread: TMS320F28034 , TMS320F280049 Our customers are looking for a DSP to replace tms320f28034, which requires at least 256K or 512k flash, and other parameters are similar to tms320f28034, which can…
Part Number: TMS320F28034-Q1 Hi Experts, Could you please let me know the AIO MUX on resistance? I believe it should be less than 100ohm. Thank you for your help. Best regards, Hitoshi
Part Number: TMS320F28034-Q1 CTM find 1pcs DSP failure with firmware download using Jlink, in mass production.The impedance of failure DSP is normal.
We want to known:
1.How can I check if the chip is locked?
2.What causes the chip to be locked?
Part Number: TMS320F28034 Hi champs,
As we can see, the number of sampling points in the FFT library is preset to 128, 256, 512, 1024.
Now my customer use FFT to preset it to 512 sampling points, but they actually only sample 500 points, will it cause…
Part Number: TMS320F28034 Hi experts,
My customer has created a board using the TMS320F28034. Let me check a few things about the device.
Can I assume that the value of the internal pullup resistor of the TMS320F28034 is as follows? (The value is calculated…
Part Number: TMS320F28034 Dear Sir,
Good afternoon,
I would like to migrate F28034 code to F28066 because of Flash is not enough for new project ,
Would you please help to tell us the key points when wo do the Migration ?
like:
1, Migration process
2,…
Part Number: TMS320F28034 Other Parts Discussed in Thread: C2000WARE Recently, I discovered that executing the same code online with an emulator is different from executing it offline without an emulator. Here is my code.
Figure 1
Figure 2
As figure 1 shows…
Part Number: TMS320F28034 Other Parts Discussed in Thread: C2000WARE Hi Champ,
I am asking for my customers.
They are using the nesting interrupt in their program.
By doing EWPM5_INT could interrupt ADC1_INT, so the total time of ADC1_INT been nesting …
Part Number: TMS320F28034 Hi expert,
My customer is using TMS320F28034 now. But there was an error of Error -1015 when downloading the code. The customer has already tested the wait BOOT mode by referring to the following link and picture 1. However, it…
