Part Number: TMS320F2808 hello. I have a question regarding the TMS320F2808 ADC.
The default settings are as follows.
AdcRegs.ADCTRL1.bit.RESET = 1U; InitAdc(); // For this example, init the ADC AdcRegs.ADCTRL1.bit.ACQ_PS = 0x0fU; AdcRegs.ADCTRL3.bit.ADCCLKPS…
Part Number: TMS320F2808 Dear TI CSC,
I noticed that the maximum erase time written on the TMS320F2808 datasheet is 15 seconds, this parameter is for the first 100 erase/program cycles. But if we erase the IC for more than 100 cycles, what is the maximum…
Part Number: TMS320F2808 Other Parts Discussed in Thread: TMS320F280049 , Hi Team,
My customer is planning to switch over to TMS320F280049 , is there any migration guide for TMS320F2808 to TMS320F280049?
Thanks.
Best Regards,
Ernest.
Part Number: TMS320F2808 I would like to write my own custom bootloader for the F2808. I have never used a TI processor, and was wondering if you can do memory writes and jumps within code without issue? Basically, I was wanting to write the bootloader…
Part Number: TMS320F2808 Other Parts Discussed in Thread: UNIFLASH Hi,
We have been updating a firmware on a TMS320F2808 chip with C2000Prog v1.2 on field devices for a long time now. It is always working perfectly with the C2000Prog SW with UI.
Since…
Part Number: TMS320F2808 Hello Team,
My customer applies the chip TMS320F2808 for motor control unit. We found out that there is a 3% failure rate during the erasing sector process in the factory. So we need to deep dive on this topic.
I searched the datasheet…
Part Number: TMS320F2808 Hi team,
Here's an issue from the customer may need your help:
The ADC is used as the interrupt trigger source and is triggered by EPWM at an epwm frequency of 18K, but it is sometimes seen that the ADC does not enter an interrupt…
Part Number: TMS320F2808 Other Parts Discussed in Thread: SYSCONFIG , C2000WARE , CONTROLSUITE I recently ordered TMS3200C2000 Experimenter Ki which came with an F2808 board. I'm trying to completed C2000 Academy (02.00.01.41) lessons but without proper…
Part Number: TMS320F2808 Dear team:
When testing the project with the following code, my customer found that when a floating-point data is given to the parameter lBalanceBRFXn , the running result of the program is correct.
When a fixed-point data is given…