Part Number: TMS320F28379D Hi, I'm working with the TMS320F28379D and trying to route ePWMs and GPIOs through the CLB (Configurable Logic Block).
From my understanding:
Each CLB tile provides 8 outputs.
The ePWMxA and ePWMxB signals are connected…
Part Number: F28377D-SEP Dear sirs, I have the well known problem of missed pulses of the ePWM unit when a sync external signal arrives.
The application is an Active Front End for the electrical 50Hz grid in a low switching frequency (900Hz) high power…
Part Number: TMS320F28379D Other Parts Discussed in Thread: LP-XDS110 Hi,
Is it possible to debug and program my TMS320F28379D custom board using only the 10-pin header in the LP-XDS110? The nTRST pin from the microcontroller is pulled-down by a 2.2k…
Part Number: TMS320F28379D Hello Forums,
I am testing an IPMSM motor control setup using a 48V DC power supply.
Test configuration:
DC supply: 48V
Motor under test controlled in no load speed mode
Controller: TMS320F28379D-176ptpt…
Part Number: TMS320F28379D Other Parts Discussed in Thread: C2000WARE Hello,
My company is developing a 3-phase power electronics system. The device selected to control and monitor the converter is the TMS320F28379D. For control purposes, we need to…
Part Number: TMS320F28379D Other Parts Discussed in Thread: UNIFLASH Hello, I made a similar ticket last night related to this issue, but I think that this could be the root cause. When trying to debug on core 1 while attached to an XDS100v3, I keep receiving…
Part Number: TMS320F28379D Other Parts Discussed in Thread: TMDXIDDK379D , C2000WARE , CONTROLSUITE Can anyone help with the source code for these source files resolver_source_CLA.cla // resolver_source_fixed.c // resolver_source_float.c used in TMDSIDDK…
Part Number: TMS320F28379D Other Parts Discussed in Thread: CONTROLSUITE , , C2000WARE When our laboratory used 28379D on-chip AD for sampling, it was found that the sampled noise was very large, so 28335 was also used for experiments, but it was found…
Part Number: TMS320F28379D Other Parts Discussed in Thread: C2000WARE We are trying to debug a dual core IPC example program with 2 separate projects for both CPU1 and CPU2 on RAM.
Below are the steps used to load the .out files and debug the projects…
