Part Number: TPA2005D1-Q1 Hi Expert,
Our customer is developing audio with TPA2005D1-Q1. At the begining of playing, a clear click noise can be heard. As below pic shows. Do you have any suggestions about that? Also, any related learning material is…
Part Number: TPA2005D1 Other Parts Discussed in Thread: TPA6211A1 I wanted to get a feedback loop from amp TPA2005D1 to set a digital potentiometer to vary the output db through software.
As this TPA2005D1 is got internally feedback circuit built in…
Part Number: TPA2005D1 Hi!
I'm trying to put lower input resistors so I can have more gain. Right now I'm trying resistors with a value of 20k, but it's causing some instability, sometimes I have signal and therefore, sound in my speakers, but other…
Part Number: TPA2005D1 Hi Team,
Our customer is interested in TPA2005D1DGN and would like to know if they can use this device to amplify a headphone output from CODEC and connect to an 8 ohms speaker?
The customer codec has some amplification factor…
Part Number: TPA2005D1 Dear,
our client use TPA2005D1 and SPK 8ohm as below schematic, and we fine tune R232 and R234 to verify GAIN.
VIN=5V
SPK=8ohm / 1.2W
Now we have question, if we change R232 and R234, from 150k to 51K, SPK could be burned…
Part Number: TPA2005D1-Q1 Other Parts Discussed in Thread: TPA2005D1 , TPA2011D1 , TAS2563 , TAS2562 Hi Expert,
Our customer currently uses TPA2005-Q1 but the output power is not enough. They are looking for replacement. The output power needs to be…
Part Number: TPA2005D1 Dear Expert
This is schemetic. Attattached PCB layout. 11-157011-02EN-V7POWER-V1.0.pdf
Two identical PCBS, both of which contain TPA2005D1DRBR circuit, were used. If the power amplifier chip on one board could work normally…
Part Number: TPA2005D1 Other Parts Discussed in Thread: TLV320DAC3101 , TAS2505 , TLV320DAC3120
Hi Team, I want to use a general-purpose speaker in one of my designs. I am planning to use the speaker AS01008MR-3-LW100-R . This speaker is 8 Ohm with…
Part Number: TPA2005D1 Hello there,
We are planning to use TPA2005D1DRBR audio amplifier for output power of 1W.
The thing is we are planning to use CR2032 or CR2477 coin cell for supplying power, the datasheet of both is attached.
Please suggest…
Part Number: TPA2005D1-Q1 Team,
well, it's all in the title. Should a filter be planned when the speaker is 10cm away and off board (hanging off wires)?
Olivier
