Part Number: TPA2011D1 Hi Experts,
The voltage in the two tables in the specification is inconsistent: Page 5 (Section 7.3) and 18 (Table 1) of the datasheet show two different input logic level (VIH and VIL) specifications for the EN pin of TPA2011D1…
Part Number: TPA2011D1 Hi teachers，
Bluetooth headset to use TI TPA2011, products are sold, after coming in phenomenon of consumer complaints has a temperature the machine (currently burned are found in use process, is not charging status, and can confirm…
Part Number: TPA2011D1 Hi Team,
The body size shows in datasheet for TPA2011D1 is 1.6mm*1.21mm
and the package information page size is not aligned as well. Could you please let us know what's the correct dimension information?
Thank you!
…
Part Number: TPA2011D1 Other Parts Discussed in Thread: TPA3136D2 , TAS5805M Hi,
could you share us the gain curve with frequency like below picture?
we mainly need the gain in 5~10 (V/V). one or two curve are enough.
we need the curves of TPA2011D1…
Part Number: TPA2011D1
Hi Team,
About the pop noise reduction method at the EN on of TPA2011D1.
Circuit specifications:
Single end, Gain 20.9 dB(Rin1,Rin2:27kΩ1%)、Fc=5.9Hz(Cin1､Cin2:1.0uF)
Power supply5.0 V, bypass capacitor: 10uF＋1uF＋0.1uF…
Part Number: TPA2011D1 Hi expert,
As title mentioned, what's the max current we might see from this audio amp.
If possible, could you please help us to point out what we shall check to get this information or how to calculate?
Thanks,
Olive…
Part Number: TPA2011D1
Hi team,
My customer is check with us about the TPA2011D1 gain set. In datasheet, it mention that the gain recommend range is <20V/V, with input resistor 15kOhm input resistor. Right now they use 13.7kohm, with 21.9V/V gain…
Part Number: TPA2011D1 Hi Experts,
Good day.
We would like to know how to compute the output power of TPA2011D1YFFR if load impedance is 32ohm.
We found THIS related thread but Cx already using the TPA2011D1.
Thanks for your attention.
Regards…
Part Number: TPA2011D1 Pls see attached file for circuitry and TPA2011 output waveform,
My question is,
over/under shoot on output signals, Is that normal?
How we can do for improvement? Thank you
TPA2011D1.docx
Part Number: TPA2011D1 A, Application Description
Input: Class D output signal connected to Qualcomm QCC3040 Bluetooth chip
Output: bone conduction sound unit connected with 8 Ω impedance.
The corresponding PCB layout is as follows:
B, Problem…
