Hey Randy,
Here are my comments on this schematic:
You have voltage powering the Shutdown Boost pin, SDb and Shutdown ClassD. SDd. These are GPIO pins and your schematic suggests they're not being treated as such. Removing the VCCOUT connections on pins…
Part Number: TPA2013D1 Hi Sirs, According to TPA2013 datasheet, it requires a Schottky Diodes to send voltage rails from SW node to VCC in boost bypass mode (Pin 6 = Low). (1) Can we connect the Schottky Diode to VDD node and remove the inductor in boost…
Part Number: TPA2013D1 Hi Team,
On datasheet, I can see Vn Output integrated noise floor @Av = 6 dB (2V/V), what about Vn Output integrated noise floor @Gain at 6V/V, 10V/V? gene-qiu@ti.com
Best Regards,
Gene
Part Number: TPA2013D1 In layout guidelines, section 12, in the datasheet recommend to have "Via to Ground Plane". Is the Via neccessary for amplification performance? Can the Via be removed for cutting down the PCB cost?
Datasheet: http://www…
Part Number: TPA2013D1 Other Parts Discussed in Thread: TAS2505-Q1 Hi Team,
My customer asks is it possible to add external an open load diagnostics to TPA2013D1?
Idea is: We use TPA2013D1 without output DC blocking capacitors . During diagnostics we…
Part Number: LM48511 Other Parts Discussed in Thread: TPA2011D1 , TPA2013D1 Tool/software: 1. When was this device launched? Also, until when is supply guaranteed?
2. Are there any recommended replacement parts?
Part Number: TPA2013D1 Hi
I am using a TPA2013D1 in an application and controlling the amplifier by connecting both the SDD and SDB shutdown pins together and controlling them from my micro.
My issue is that whenever i place the amplifier into shutdown…
Part Number: TPA2013D1 Hi team,
my customer wants to remove DC blocking capacitors from PCB with TPA2013.
Will the device able to operate without DC blocking capacitrors?
What possible issues we can expect?
