Part Number: TPA2018D1 Other Parts Discussed in Thread: TAS2320 , TAS2770 Hello,
My customer is looking for a TI product to replace the ADI SSM6515.
This product is mono, but stereo is fine. Please recommend the most suitable replacement among TI…
Hi, Don,
Welcome to E2E and thank you for your interest in our products!
This should be a typo on the EVM User's Guide. The TPA2018D1 is capable to achieve 3W into a 4 ohms load. It is actually shown in the electrical characteristics data.
We will…
Hi, Don,
Could you also install the latest NI-VISA drivers?
Also, did you already installed the TPA2018D1 EVM GUI?
Best regards, Luis Fernando Rodríguez S.
Other Parts Discussed in Thread: TPA2018D1 art Number: TPA2018D1YZFEVM
Hello,
I haveTPA2018D1YZF Evaluation Module.
When I downloaded TPA2018D1 Interface i took "I2C Failure" error. Drivers looks okay. I upload last NI VISA Drivers. What should…
Other Parts Discussed in Thread: TPA2018D1 , TPA6130A2 , TPA2028D1 Hi,
Is there a place where to download TPA2028DA, TPA2018D1, TPA6130A2 and TS3A227 I2C drivers ?
Thanks Nicolas
Other Parts Discussed in Thread: TPA2018D1 , TPA2028D1 We're currently using TPA2018D1 as audio PA . It seems that you've recently released 'updated' version TPA2028D1. If we have SW interfaces developed and surrounding HW designed for 2018 available…
The datasheet doesn't discuss input impedance.
What is the input impedance, and does it change with a change in gain from the AGC?
Thank you,
Michael O.
Other Parts Discussed in Thread: TPA2018D1 Hi,
On the TPA2018D1, may the EN pin be used as a MUTE during system startup ? Or, in other words, is there any issue in delaying the low-to-high transition on the EN pin after the power has been applied to…
Part Number: TPA2016D2 Other Parts Discussed in Thread: TPA2018D1
Hi,
We're using an array of TPA2016D2s to drive multiple coils (one coil per IC) on a very dense PCB, so minimizing routing is critical. Frequencies are from 20Hz to 15KHz.
Only the…
Part Number: TPA2017D2 Other Parts Discussed in Thread: TPA2018D1 Hello,
I have two questions about AGC. Could you help me?
Is my understanding about Figure 2. OUTPUT LEVEL VS INPUT LEVEL correct?
In Table 1, "(AGC1, AGC2) = (0, 1), AGC Limiter…
