Part Number: TPA3008D2 Hi Sir,
Does TI have 10W stereo output Class-D amplifier solution with integrate Codec?
If not, what is your suggestion for only Class-D amplifier?
Thanks!
Jeff
Part Number: TPA3008D2 Hi Sir,
We have put the TPA3008D2 in our board , the function looks fine. except one issue, we controlled the Mute/ un-mute through Shutdown pin (Mcu will sent a pull low or high signal to Shutdown pin) but there is always a big…
Other Parts Discussed in Thread: TPA3008D2 , TPA3137D2 , TPA3111D1 I'm looking for a class D power amp that will get a signal from audio codec SGTL5000.
The analog headphone output will enter the amplifier. The SGTL5000 datasheet says a
16 Ohm load…
Other Parts Discussed in Thread: TPA3008D2EVM , TPA3008D2 I've built a small amp based on this EVM (http://focus.ti.com/docs/toolsw/folders/print/tpa3008d2evm.html), and it seems to be working fine, until i connect cables to the input ...
Static noise…
Matthew, I have attached the presentation that goes with the video. The video itself can be viewed over the video link provided earlier.
The presentation link provided earlier points to a different presentation, a later one on PCB layout for audio…
Hi Chad,
I'm glad that it worked out. The problem is caused by the ferrite beads saturating at high current level. I have attached a ppt that explains the saturation issue and FB filtering from pg 45 to pg 50. In the last few pages, there is some good…
Tomasz, I'm not sure I understand your questions, but I will try to answer. Minimum inductance is indicated on page 4 of data sheet SLES220B, as "Minimum output iInductance at Ioc". It is absolute for the level of Iocp that is programmed with Rocp. If…
Bruce, I am concerned about the layout around TAS5630, because it is rather different from the EVM. The data sheet points out several things that are important to performance in the section called Printed Circuit Board Recommendation, and the EVM should…
