Search tips
Showing 46 results View by: Thread Post Sort by
    Answered

  • RE: TPA3100D2 popping

    Resolved
    :) I like it! -d2
    • Answered

  • TPA3138D2: sync question about TPA3138D2

    Resolved
    Part Number: TPA3138D2 Other Parts Discussed in Thread: TPA3100D2 , TPA3118D2 Hi Sir, My customer is interesting about sync function in TPA3138D2. Please help to check below questions. 1. Why there need 4.7k resistor between two TPA3138D2? 2. Is there…
    • Resolved

  • TPA3100D2 SYNC Operation

    Other Parts Discussed in Thread: TPA3100D2 , TPA3101D2 The TPA3100D2, TPA3101D2, and TPA3106D2 have SYNC terminals which allow the internal oscillator to be sync'd up with a second device, or your SMPS. The data sheet describes how to use this, but…
    • Answered

  • TPA3111D1: thermal model request: PDML format

    Resolved
    Part Number: TPA3111D1 Other Parts Discussed in Thread: TPA3100D2 , Hi team, As the thermal performance becoming increasingly demanding in products on the vehicle, one of my customers decided to do thermal simulation validation. Could you help provide…
    • Resolved

  • PCM3070

    Other Parts Discussed in Thread: PCM3070 , TPA3100D2 , PCM3070RHBEVM-K I've got a problem with the PCM3070. I opened in the Pure Path Studio the example /Parametric EQ If I change the Gain Parameter of the Equalizer,there is no change. The second problem…

  • LM48901

    Other Parts Discussed in Thread: TPA3100D2 , TPA3110D2 Hi, A couple of questions in regards to this chip 1)How do you connect more than 4 speakers to the device (we are looking at 6 speakers) 2)Can we use the output to drive a higher power amp secti…

  • More than one speakers

    Other Parts Discussed in Thread: TPA3123D2 , TPA3100D2 , TAS5414A Dear Sir, I am testing the TPA3123d2. It seems that I cannot connect many(e.g. four) 8 ohm speakers at the BTL output of TPA3123d2, why? Thanks. Regards, Eddie

  • RE: Beat Noise in Class-D Audio

    One case may cause beat noise: The input signal pick up switching signal of different frequency and amplified by following amplifier. 1) the input amplify stage is non-linear at high frequency, beat frequency is generated. 2) the modulation stage is non…
    • Answered

  • Re: how to get a lower output impedance of a class d ampli

    Resolved
    Thanks Nate for your answer I take a 20w stereo class d as TPA3100D2 . In the data sheet it can output 15W/ch 4 ohms. If i do the BTL link, do i can have 30W in a single chanel of 2 ohms. Is there a limite to put 2 x TPA3100D2 in BTL to have 60W in…
    • Answered

  • Re: Class D Amplifier for 20W at 2 Ohms

    Resolved
    Hi, Bill, 2-ohms is not a typical speaker impedance our customers use, and is a much more challenging load to drive. You could use something like TPA3100D2 set up in parallel-BTL operation as shown in figure 4 of http://focus.ti.com/lit/an/sloa121a/sloa121a…

Didn't find what you are looking for? Post a new question.