Part Number: TPA3110D2 hello;
We're studying on a new design with TPA3110D2. We've adjusted it as single ended inputs which are coming from Audio Codec with Stereo BTL outputs. Sometimes it works fine for 2-3 days and gets fault. Sometimes, as soon…
Part Number: TPA3110D2 Dear Sir,
We are using TPA3110D2PWPR IC for 20W full range speaker and PBTL mode , Single Ended Input signals.
When we are connecting LINP (HP_L), RINP(HP_R), AGND/DGND(AGND/DGND) and LINN,RINN to DGND then we are found hum…
Part Number: TPA3110D2 I would like to use two TPA3110D2 stereo amplifiers to create a four channel amplifier so the two devices will be working close to each other.
Are there likely to be any issues with having two same frequency oscillators in close…
Part Number: TPA3110D2-Q1 Hi,
we are designing power amplifier for audio application. need following support,
1. Output power delivered to load in BTL configuration
2. Power dissipation by TPA3110D2-Q1
Regards
Amit Niungare
+91-703093…
Part Number: TPA3110D2 Hi team,
May we get your support to double-check the schematic and comment on whether we need to make any changes? Thanks!
Best regards,
Sam Ting
Part Number: TPA3110D2 Hi,
I've made an attempt at an audio circuit using the TPA3110D2, however I'm having issues with the output. I've made a few modifications compared to the reference design on the datasheet, like adding transformers between the…
Part Number: TPA3110D2 Dear All,
In TPA3110D2 spec sheet, there is a description of necessary slew rate of gain setting pins as below:
9.3.2 Gain Setting Via GAIN0 And GAIN1 Inputs The gain of the TPA3110D2 is set by two input terminals, GAIN0 and…
Part Number: TPA3110D2 Work voltage:26V
loudspeaker:20W 4Ω
volume:85%
The Loudspeaker stalled when playing some music.Like the 27.mp3.
The speaker stuck for 1 minute and 24 seconds of the music, then returned to normal after 400ms.
As can be…
Part Number: TPA3110D2 Hello,
Regarding to unused output on TPA3110D2, my customer is asking some question.
(Question)
When they used only input/output right channel as monaural output on BTL, they will design termination to left output channel…
